Pull cooler, higher-volume air into your truck with the aFe Power Magnum FORCE Stage-2 Cold Air Intake System (MPN 51-32642-1B). It installs as a direct bolt-on replacement for the 2015-2025 Ford F-150 V6-2.7L (tt) and the 2015-2016 Ford F-150 V6-3.5L (tt), and it ships with the mounting hardware and heat shield needed to fit.
Built around a Magnum FORCE Stage-2 layout, it swaps the restrictive factory setup for a free-flowing, washable system.
Includes mounting hardware and an air-filter heat shield. Made in the United States.
Which vehicles does this intake fit?
It is a direct bolt-on for the 2015-2025 Ford F-150 V6-2.7L (tt) and the 2015-2016 Ford F-150 V6-3.5L (tt). Check the Buyer's Guide tab to confirm your engine.
Does it require cutting or drilling to install?
No. The one-piece 16-gauge powder-coated heat shield is designed to bolt on without cutting or drilling, and the mounting hardware is included.
Is the air filter reusable?
Yes. The 360-degree radial-flow filter uses 3-layer cotton/synthetic gauze media that is washable and reusable, and it is backed by a limited lifetime warranty.
What does the heat shield and sealed airbox do?
The powder-coated heat shield and sealed, rotomolded airbox block engine heat and direct cooler air to the filter, helping restore proper airflow while quieting intake noise.
Is any hardware included?
Yes. The kit includes the mounting hardware and the air-filter heat shield needed for installation. It is made in the United States.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
