Anchor Automatic Transmission Mount,Manual Transmission Mount P/N:2619
$24.99
(You save)
Quiet driveline vibration and keep the rear of your transmission securely located with the Anchor Rear Transmission Mount 2619. This rear-position mount helps support and locate the transmission while isolating the vibration and movement that reaches the chassis. It installs as a direct-fit replacement for the 1968-1979 Lincoln Continental, 1968-1971 Lincoln Mark III, and 1977-1979 Lincoln Mark V — see the Buyer's Guide tab for engine-level details.
Bonded rubber-to-metal build: molded from natural and Styrene Butadiene rubber with a Chemlock® bonding agent for a strong rubber-to-metal bond that resists wear and stays stable as it ages.
Application-matched hardness: the rubber is manufactured to a specific Durometer (hardness) measurement based on the vehicle's requirements.
Engineered to OE standards: designed using a CAD/CAM engineering process for consistent quality.
Supports and dampens: helps support the transmission at the rear while absorbing vibration.
Signs the original mount may need replacing include clunks on acceleration, deceleration, or shifting, added vibration at idle, and cracked or separated rubber. If a worn rear transmission mount is the cause, this replaces it.
Interchange: 313392 · A2619 · D6VY6068A · EM2619
This part cross-references / interchanges with the following part numbers:
313392, A2619, D6VY6068A, EM2619
Manufacturer's Warranty: 12 Month Warranty.
Frequently Asked Questions
What does this transmission mount do?
It helps support and locate the transmission at the rear while isolating vibration and limiting movement between the transmission and the chassis.
Which vehicles does the Anchor 2619 fit?
It's a direct-fit rear mount for the 1968-1979 Lincoln Continental, 1968-1971 Lincoln Mark III, and 1977-1979 Lincoln Mark V. Check the Buyer's Guide tab to confirm your vehicle.
What are the signs of a worn transmission mount?
Clunks on acceleration, deceleration, or shifting, extra vibration at idle, and cracked or separated rubber can all indicate a failing mount.
What is this mount made of?
It uses natural and Styrene Butadiene rubber bonded to metal with a Chemlock® bonding agent, molded to an application-specific Durometer hardness.
What are the interchange numbers for this part?
This mount cross-references 313392, A2619, D6VY6068A, and EM2619.
Write a Review
Anchor
Anchor Automatic Transmission Mount,Manual Transmission Mount P/N:2619
Quiet the driveline and keep your gearbox planted with the Anchor Rear Transmission Mount 2784, the rear automatic transmission mount that fits the 1994-1998 Ford Mustang and the 1986-1988 Mercury...
Support the transmission and tame driveline vibration with the Anchor Transmission Mount 9217, the left-hand mount. It drops in as a direct-fit replacement on many vehicles, among them the 2000-2006...
Steady the driveline and keep the gearbox properly located with the Anchor Transmission Mount 8888, the left-side mount that supports the transmission and dampens vibration. It fits many vehicles,...
Quiet the driveline and keep your gearbox properly located with the Anchor Transmission Mount 2912, the left-side mount that supports the transmission and dampens vibration. It installs as a...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
