Damp driveline vibration and keep the rear of your transmission properly supported with the Anchor Transmission Mount 2882. It installs as a direct-fit replacement in the rear transmission-mount position on the 1997-2006 Jeep TJ and 1997-2006 Jeep Wrangler, helping to support and locate the powertrain while isolating vibration and limiting excess movement.
Worn mount signs include vibration at idle, a clunk on acceleration, deceleration or shifting, and cracked or separated rubber. If a failed rear transmission mount is the cause, this replaces it. Consult the vehicle service information for the correct fasteners and whether they may be reused.
Interchange: 017-5937-4
01759374 · 6201579 · 312882 · MT2882 · A2882 · 52058551AB · 622882 · 2906184 · 1410 · EM2882
This part cross-references / interchanges with the following part numbers:
Manufacturer's Warranty: 12 Month Warranty.
What does this transmission mount do?
It helps support and locate the rear of the transmission while isolating vibration and limiting excess powertrain movement.
Which vehicles does the Anchor 2882 fit?
It is a direct-fit replacement for the 1997-2006 Jeep TJ and 1997-2006 Jeep Wrangler. Check the Buyer's Guide tab to confirm your exact vehicle.
What position is this mount?
It is the rear transmission-mount position for the listed applications.
What are signs my transmission mount needs replacing?
Vibration at idle, a clunk on acceleration, deceleration or shifting, and cracked or separated rubber. Diagnose the cause before replacing.
Are mounting bolts included?
Hardware inclusion is not confirmed here. Consult the vehicle service information for the correct fasteners and whether they may be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
