Quiet your exhaust and route spent gases cleanly out the back with the AP Exhaust muffler assembly (MPN 2075), a welded, bolt-on replacement for the 2007 Mazda CX-9 (V6-3.5L) and 2008-2015 Mazda CX-9 (V6-3.7L). This baffled, direct-fit unit is tuned to match the factory exhaust note so your CX-9 sounds the way it should after the swap.
Overall length is 21.625", with a 12.000" x 11.000" x 5.500" body. No heat shield is attached. Backed by a Limited Lifetime Warranty. Country of origin: United States. Signs the original muffler may need replacing include a louder or raspy exhaust note, rattling from loose internal baffles, or visible rust-through and holes in the shell.
Manufacturer's Warranty: Limited Lifetime Warranty.
Does this AP Exhaust muffler assembly fit my Mazda CX-9?
It is a direct-fit replacement for the 2007 Mazda CX-9 (V6-3.5L) and the 2008-2015 Mazda CX-9 (V6-3.7L). Confirm your engine against the Buyer's Guide tab.
What is the muffler made of?
The body is constructed from aluminized steel for corrosion resistance, and it is a welded assembly.
Will it change how my exhaust sounds?
It is tuned to match the original equipment tone, so it is designed to preserve the factory exhaust note after installation.
What are the inlet and outlet sizes?
It has a single 2.000" inlet located at left center and a single 2.000" spout outlet at right center. Overall length is 21.625".
Is a heat shield included?
No, a heat shield is not attached to this muffler assembly. Transfer or replace any required shield as directed by the service procedure.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
