Beck/Arnley Steering Tie Rod End P/N:101-8408
Keep your steering tight and responsive with the Beck/Arnley Steering Tie Rod End 101-5511, a 2003-2008 Mazda 6 tie rod that drops in as a direct-fit replacement (see the "Vehicles it fits" section for engine-level fitment). This is the front right outer tie rod end, connecting the steering linkage to the steering knuckle so steering input translates into accurate toe and steering control.
Worn tie rod ends may show up as loose or wandering steering, uneven or accelerated tire wear, a clunk or rattle over bumps, or play felt at the wheel. If a failed front right outer tie rod end is the cause, this 101-5511 replaces it. After replacing any tie rod end, have the wheel alignment set to spec.
Interchange: 1001353 · SE1631R · 61245031 · TO65032XL · 43932059591 · G26A32280 · 3432901 · TO65032 · ES800027 · GJ6E32280A · ES4295 · MS76604 · JTE7585
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Will this Beck/Arnley tie rod end fit my 2003-2008 Mazda 6?
It is a direct-fit replacement for the 2003-2008 Mazda 6. Check the "Vehicles it fits" section to confirm the engine-level fitment for your specific vehicle.
What position is this tie rod end?
This is the front right (passenger side) outer tie rod end.
Is the ball joint pre-greased?
Yes. The ball joint comes pre-greased, and a full ball stud is used.
How is it protected against rust?
The part is coated or plated for corrosion protection.
Do I need an alignment after a tie rod replacement?
Yes. Replacing an outer tie rod end changes toe settings, so have the wheel alignment set to specification afterward.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.