Looking for a 2007-2011 Honda CR-V tie rod? The Beck/Arnley Tie Rod End 101-6868 is a front inner tie rod end that drops in as a direct-fit replacement for the 2007-2011 Honda CR-V. It connects the steering linkage to allow toe adjustment while transmitting your steering input, and Beck/Arnley designs it to match OE applications across foreign nameplates.
- OE form, fit and function: designed to match the form, fit and function of the original front inner tie rod end.
- Corrosion protection: coated or plated to resist rust.
- Pre-greased ball joint: the ball joint comes greased and ready to install.
- Easy-access wrench flat: lets you use a socket for straightforward installation and removal.
- Full ball stud: the tie rod end is built with a full ball stud.
Loose or wandering steering, clunking when turning, noticeable play in the linkage, and uneven or accelerated tire wear can all be signs a worn tie rod end may need replacing. If a failed front inner tie rod end is the cause, this Beck/Arnley steering tie rod end replaces it. An alignment is recommended after installation.
Interchange: 53010SWAA01 · SRH020 · 61240074 · TI59060 · EV800689 · ES4528 · MS60716
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
Is this the right tie rod end for a 2007-2011 Honda CR-V?
Yes, it's a direct-fit front inner tie rod end for the 2007-2011 Honda CR-V. Check the "Vehicles it fits" section to confirm the correct part for your engine and trim.
Is this a genuine Beck/Arnley tie rod end?
Yes. This is the Beck/Arnley tie rod end 101-6868, designed to match OE form, fit and function for foreign-nameplate applications.
What are the signs a tie rod end needs replacing?
Loose or wandering steering, clunking when turning, play in the steering linkage, and uneven or accelerated tire wear can be signs the tie rod end may need replacing.
Does the ball joint come pre-greased?
Yes, the ball joint is pre-greased. The part is also coated or plated for corrosion protection.
Do I need an alignment after installing it?
An alignment is recommended after replacing a tie rod end, since it affects toe. Consult the vehicle service information for the correct procedure and specifications.
Reviews
No reviews yet — be the first to review this product.
Write a ReviewWrite a Review