Help firm up a loose, wandering steering feel with the Beck/Arnley Steering Tie Rod End (MPN 101-7881), a front left outer tie rod end that installs as a direct replacement on the 2013-2017 Honda Accord and 2015-2020 Acura TLX. This tie rod end links the steering linkage to the steering knuckle, transmitting steering input to the front wheel while its ball stud pivots to allow steering and suspension travel.
Beck/Arnley parts are designed as direct replacements for Original Equipment applications across foreign nameplates, with attention to form, fit and function. Key features:
- OE match: matches OE form, fit and function.
- Corrosion protection: coated or plated to resist rust.
- Pre-greased ball joint: the ball joint comes pre-greased.
- Easy-access wrench flat: allows a socket to be used for straightforward installation and removal.
- Full ball stud.
Signs the original outer tie rod end may need replacing include play or looseness in the steering, a clunk from the front end, uneven front tire wear, or steering that feels vague. If a worn tie rod end is the cause, this replaces it — have the front end diagnosed and an alignment performed after installation. See the "Vehicles it fits" section for engine-level fitment.
Interchange: 53560T2AA01 · 61240112 · TO59271 · ES801001 · MS60636
This part cross-references / interchanges with the following part numbers:
53560T2AA01, 61240112, TO59271, ES801001, MS60636
Frequently Asked Questions
Is this the right tie rod for a 2013-2017 Honda Accord?
Yes. This Beck/Arnley 101-7881 tie rod end is a direct-fit replacement for the 2013-2017 Honda Accord, as well as the 2015-2020 Acura TLX. Check the "Vehicles it fits" section to confirm your engine.
Is this an inner or outer tie rod end?
This is a front left outer tie rod end. If you need an inner tie rod, that is a separate part and is not this listing.
Which side of the vehicle does this outer tie rod end fit?
It is cataloged as the front left (driver-side) outer position for the listed applications.
Does the ball joint come greased?
Yes. The ball joint is pre-greased. The part is also coated or plated for corrosion protection and uses a full ball stud.
Do I need an alignment after installing it?
Yes, a wheel alignment is recommended after replacing any tie rod end so front-end geometry and toe are set correctly, which helps keep tire wear even.
