Keep your steering tight and precise with the Beck/Arnley Steering Tie Rod End 101-8506, a front inner tie rod end that drops in as a direct replacement for the 2016-2023 Mazda CX-9. A worn Mazda CX-9 tie rod can lead to loose, wandering steering and uneven front tire wear, and if a failed tie rod end is the cause, this replaces it and reconnects the steering linkage to help transmit driver input to the front wheel.
This is a front inner tie rod end. Tie rod ends install as left/right pairs on many vehicles; replacing both sides together is a good practice for balanced steering feel. Consult the vehicle service information for the correct torque and any single-use fasteners.
Interchange: 2600604853 · EV801574 · TK4832240 · MS76724
This part cross-references / interchanges with the following part numbers:
Does this tie rod end fit my Mazda CX-9?
Yes, the Beck/Arnley 101-8506 is a direct replacement for the 2016-2023 Mazda CX-9. See the Buyer's Guide tab to confirm your exact vehicle.
Is this a front inner or outer tie rod end?
This is a front inner tie rod end for the listed application.
What are the signs a tie rod end may need replacing?
Loose or wandering steering, uneven front tire wear, and play or clunking in the steering linkage may indicate a worn tie rod end. Have the cause diagnosed before replacing.
Does the ball joint come greased?
Yes, the ball joint is pre-greased. The full ball stud also has an easy-access wrench flat so a socket can be used for installation and removal.
Should I replace both tie rod ends at once?
Tie rod ends install as left/right pairs on many vehicles. Replacing both sides together is a good practice for balanced, even steering feel, though this listing is for one unit.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
