Smooth out that worn rear ride and tame the clunks with the Beck/Arnley Suspension Control Arm Bushing 101-5307, a direct-fit Honda crv compliance bushing for the 1997-2001 Honda CR-V. This rear bushing cushions the joint where the control arm mounts to the chassis, isolating vibration and helping the suspension locate the arm through its travel.
If your rear Honda Cr-v control arm bushing has cracked, split, or gone soft, you may notice a clunk on acceleration or over uneven pavement, imprecise handling, or uneven tire wear. If a failed bushing is the cause, this replaces it. Consult the vehicle service information for the correct fasteners and whether they may be reused.
Interchange: 523012 · 52385SR3003 · BC59550 · MS60432
This part cross-references / interchanges with the following part numbers:
What vehicle does this bushing fit?
It is an application-specific direct replacement for the 1997-2001 Honda CR-V. See the Buyer's Guide tab to confirm the fit for your vehicle.
Where is this bushing located?
This is a rear suspension control arm bushing. It cushions the mount where the control arm attaches to the chassis, isolating vibration and helping locate the arm.
What is this bushing made from?
It is made from a high grade rubber compound with quality construction, and is resistant to heat, wear, salt, road grime, and oils.
What are signs this bushing may need replacing?
Cracked, split, or soft rubber, a clunk on acceleration or over bumps, and vague handling. Diagnose the cause before replacing, since these signs can have other sources.
Which part numbers does this cross-reference?
It interchanges with 523012, 52385SR3003, BC59550, and MS60432.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
