Beck/Arnley Suspension Control Arm P/N:102-6596
Keep the front suspension located and tracking true with the Beck/Arnley Suspension Control Arm 102-4804. It drops in as a direct replacement for the 1997-2001 Honda CR-V, serving the front right lower position and connecting the wheel knuckle to the chassis while its bushings help isolate road vibration. See the Buyer's Guide tab for the full engine coverage.
A worn control arm or its bushings can show up as clunking over bumps, uneven tire wear, or a steering pull. If the original arm is the cause, this replaces it and helps restore proper wheel location and alignment. For best results, have an alignment performed after installation.
Interchange: 45D3258 · 1012981 · 62240839 · HNH222 · 520650 · 51350S10A00 · 37121048591 · RK640324 · FA4261 · CMS20115 · 5071258 · 12735 · W01331600039
This part cross-references / interchanges with the following part numbers:
Will this control arm fit my vehicle?
It is a direct replacement for the 1997-2001 Honda CR-V, serving the front right lower position. Check the Buyer's Guide tab to confirm it matches your exact vehicle.
Does it include a ball joint?
No. This control arm comes without a ball joint, which matches the OE design for these applications.
Are hardware and bushings included?
New hardware and bushings are included where applicable, and the part is application-specific for this vehicle.
What are the signs of a worn control arm?
Common signs include clunking over bumps, uneven or accelerated tire wear, and steering pull or wander. Have the cause diagnosed before replacing.
Should I replace the other side too?
This listing covers the front right lower arm. Inspecting and, if worn, replacing the opposite side is good practice for balanced handling; an alignment afterward is recommended.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.