Keep your rear suspension located and controlled with the Beck/Arnley Suspension Control Arm 102-7090 (also written 1027090), a direct-fit rear upper control arm for the 2002-2007 Mitsubishi Lancer. A control arm connects the wheel knuckle to the chassis and helps guide wheel movement while holding suspension geometry, so worn or damaged arms and bushings can lead to clunking, uneven tire wear, and loose handling — signs this part may need replacing.
Because it is application-specific, install the arm using the vehicle service information for the correct torque specs and hardware.
Interchange: 62246832 · CA67515 · MS801010 · MR491911
This part cross-references / interchanges with the following part numbers:
What vehicle does this control arm fit?
It is a direct-fit replacement for the 2002-2007 Mitsubishi Lancer. See the Buyer's Guide tab to confirm the exact application for your vehicle.
Is this a front or rear control arm?
This is the rear upper suspension control arm for the listed application.
Does it include a ball joint?
No. This control arm comes without a ball joint, which matches the OE design.
Are bushings and hardware included?
New hardware and bushings are included where applicable. This arm is application-specific for the listed vehicle.
What are common signs a control arm needs replacing?
Clunking over the suspension, uneven tire wear, and loose or wandering handling can indicate worn arms or bushings. Diagnose the cause before replacing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
