Centric Parts Brake Hydraulic Hose P/N:150.48028
Carry brake fluid from the chassis line to the wheel with the Centric Parts brake hydraulic hose, part number 150.66106, cataloged for the front left position. It fits many vehicles, among them the 2002-2009 Chevrolet Trailblazer, 2002-2009 GMC Envoy and 2003-2006 Chevrolet SSR, as a direct-fit replacement for the listed applications. See the "Vehicles it fits" section for the full list and engine details.
Centric says its brake hose line offers the widest application coverage in the aftermarket, and it describes these hoses as the highest-quality aftermarket replacements.
Signs a brake hose may need replacing include cracking, bulging or chafing on the outer surface, fluid seepage at the fittings, a soft or spongy pedal, and the vehicle pulling to one side under braking. These symptoms can have other causes, so inspect the brake system before you replace parts. If the front left hose is the cause, this part replaces it. After installation, bleed the brakes. Check the vehicle service information for the correct fittings, sealing washers and torque values.
Product information is for general reference and may contain errors. See our Disclaimer.
What does the Centric Parts 150.66106 brake hydraulic hose do?
It carries pressurized brake fluid from the rigid brake line to the front left wheel's brake, and it flexes as the suspension and steering move.
Which vehicles does this brake hose fit?
It fits many vehicles, including the 2002-2009 Chevrolet Trailblazer, 2002-2009 GMC Envoy and 2003-2006 Chevrolet SSR. See the "Vehicles it fits" section to confirm your exact vehicle.
Which position is this hose for?
This listing is cataloged for the front left position. Replacing the hoses on both sides of an axle at the same time is often recommended for balanced braking.
What are signs a brake hose may need replacing?
Look for cracks, bulges or chafing, fluid seepage at the ends, a spongy pedal, or pulling to one side when braking. These signs can have other causes, so inspect the system first.
Do I need to bleed the brakes after installing it?
Yes. Opening the hydraulic system lets air in, so bleed the brakes afterward. Follow the vehicle service information for fittings, sealing washers and torque values.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.