CARDONE New CV Axle Assembly P/N:66-1358
CARDONE New 66-2161 rear right CV axle for the 2003-2006 Ford Expedition and other vehicles carries drive torque to the wheel while the suspension moves. This CV axle assembly includes its CV joints, and its design targets the reasons original CV axles typically fail, starting with the boot.
Clicking or snapping on turns, a thump or vibration when you accelerate, or grease thrown from a torn boot can mean an axle is worn. These signs alone do not prove the axle is at fault, since a worn hub bearing can make similar noises. Axles on the two sides are normally swapped as a pair, so the rear left is ordered separately.
It is a direct-fit replacement for the 2003-2006 Ford Expedition and the 2003-2006 Lincoln Navigator.
Fit and size
Build and materials
One complete rear right CV axle with a new axle retaining nut and an instruction sheet. This listing is one axle; the rear right takes one.
Interchange: 4L1Z4K138AA · 4L1Z4K138AB · 4L1Z4K138AC
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the CARDONE New 66-2161 rear right CV axle right for the 2003-2006 Lincoln Navigator?
Yes. CARDONE New 66-2161 is a rear right CV axle listed for the 2003-2006 Lincoln Navigator and the 2003-2006 Ford Expedition.
Does this CV axle come with a new axle nut?
Yes. CARDONE New 66-2161 ships with a new M24x2.0 hex axle retaining nut and an instruction sheet, since the original nut is often worn or stripped. The ABS tone ring is not included.
What is the shaft diameter and spline count on this CV axle?
The shaft is 32 mm (1.26 in) across, with 34 splines on the inboard joint and 33 on the outboard joint. Compressed length is 874 mm (34.409 in).
What happens when the boot on a CV axle cracks or tears?
A cracked or torn boot lets grease out and lets water and dirt in, which can damage the joint. Grease around the boot is a reason to have the axle inspected by a shop.
Can I use an impact wrench to tighten the nut on this rear right CV axle?
No. Use a torque wrench on the retaining nut and tighten it to the manufacturer's specifications; an impact wrench should not be used.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.