CARDONE New CV Axle Assembly P/N:66-3541
CARDONE New 66-3311 front left CV axle for the 2004 Dodge Verna and other vehicles sends drive torque from the transaxle to the front left wheel. This CV axle assembly was engineered around the reasons original axles typically fail, to avoid a repeat failure.
Clicking or snapping when you turn under power, grease flung around the suspension, or a vibration when you accelerate can mean the CV joint or boot is worn. Before replacing the axle, look over the boot with the engine off for splits or grease spray. If it looks intact, a shop can check the engine mounts and hub.
It fits the 2004 Dodge Verna and is also a CV axle for the 2000-2002 Hyundai Accent, built to O.E. form, fit and function. Axles on both sides are normally replaced together; this listing is a single front left axle, and the front right is ordered separately.
Fit and size
Build and materials
One complete CV axle with a new axle retaining nut, and an instruction sheet.
Interchange: 4950025400 · 4950025500 · 4950025501
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the CARDONE New 66-3311 fit the 2000-2002 Hyundai Accent?
Yes, the CARDONE New 66-3311 front left CV axle fits the 2000-2002 Hyundai Accent, and the 2004 Dodge Verna takes it as well. Each car takes one front left axle.
Does the 66-3311 front left axle come with a new axle nut?
Yes, CARDONE New 66-3311 comes with a new axle retaining nut, along with the complete CV axle and an instruction sheet. The ABS tone ring is included.
What thread and socket size is the axle nut on this front left CV axle?
The retaining nut is a hex nut with an M22x1.5 thread and a 32 mm (1.26 in) socket size. It is 21.5 mm (0.846 in) long.
What does clicking when I turn with the wheel cut hard mean on a CV axle?
A clicking or snapping noise when turning under power can mean the outer CV joint is worn. A torn boot with grease on the suspension is another sign; a shop can confirm which part is at fault.
Which nut do I use to install CARDONE New 66-3311?
Always discard the old prevailing torque lock nut and use the new retaining nut that ships with CARDONE New 66-3311. Tighten it with a torque wrench to the manufacturer's specification, not an impact wrench.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.