CARDONE New CV Axle Assembly P/N:66-3541
A1 CARDONE 66-6299 front left CV axle for the 2013 Infiniti EX37 and other vehicles carries drive torque to the front left wheel. Its design targets the reasons original CV axles typically fail, starting with boot cracking.
Clicking when turning hard under power, a thump or vibration on acceleration, or grease on the chassis can mean a worn joint or torn boot. These signs alone do not prove the axle is at fault; a broken engine mount can also bind the inner joint. Each front wheel takes one axle; this listing is the front left, the front right is a separate part, and both sides are normally replaced together.
The 2013 Infiniti EX37, the 2009-2013 Infiniti G37 and the 2008-2012 Infiniti EX35 take this axle, along with other vehicles, and its engineering process is meant to meet O.E. form, fit and function. If your car is not named here, find your year and model in the "Vehicles it fits" section.
Fit and size
Build and materials
One complete CV axle with its CV joints, a new axle retaining nut and an instruction sheet.
Interchange: 39101EJ71A
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this 2009-2013 Infiniti G37 cv axle the front left one?
Yes. A1 CARDONE 66-6299 is the front left axle for the 2009-2013 Infiniti G37; the front right side is a separate part.
Does the A1 CARDONE CV drive axle come with a new axle nut?
Yes. A1 CARDONE 66-6299 comes with its CV joints, a new hex axle retaining nut and an instruction sheet. The ABS tone ring is not included.
What size are the shaft and axle nut thread on this front left CV axle?
The shaft diameter is 27 mm (1.063 in). The axle nut has an M24x1.5 thread and a 36 mm socket size.
How do I spot a failed boot on this neoprene-boot axle?
Look, with the car parked and cool, for a split boot or grease on nearby chassis and suspension parts. A torn boot lets grease out and lets water and dirt in to damage the joint.
Can I use an impact wrench on the retaining nut of the 66-6299 axle?
No. Use a torque wrench and tighten the nut to the manufacturer's specification, and fit new transaxle seals when replacing the axle.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.