Rear Right Brake Caliper for 2006-2012 Mitsubishi Eclipse & More - A1 CARDONE 2C-2966

$151.99

Vehicles this part fits

    Part number: 2C-2966
    UPC: 884548295742
    Condition: New
    Weight: 6.30 LBS
    Item Package Quantity: 1
    $151.99
    Adding to cart… The item has been added

    Have questions?

    CARDONE New Disc Brake Caliper P/N:2C-2966
    CARDONE New Disc Brake Caliper P/N:2C-2966
    $151.99
    $151.99

    A1 CARDONE 2C-2966 rear right brake caliper for the 2006-2012 Mitsubishi Eclipse and other vehicles clamps the brake pads against the rotor to slow the wheel. It is a new, unloaded, direct-fit floating caliper built to meet or exceed O.E. performance.

    • Zinc-plated finish with a rust-resistant coating gives a silver look
    • Cast iron body with a single steel piston in a floating design
    • Every unit is 100% tested for reliable performance
    • Inverted flare inlet fitting and an M7x1.0 bleeder thread
    • Suited to commercial use as well as performance vehicles

    Quick facts

    • Part: A1 CARDONE 2C-2966 brake caliper
    • Also called: disc brake caliper
    • Fits: 2006-2012 Mitsubishi Eclipse and other vehicles
    • Position: Rear right
    • Material: Cast iron body, steel piston
    • Condition: New

    A sticking or leaking caliper can show up as the car pulling to one side under braking, uneven pad wear or fluid around the caliper, but worn pads, sticky slides or a restricted hose can cause these too. Before replacing it, look over the caliper slides, pins and brake hose during a brake service with the engine off.

    Fits

    It fits the 2006-2012 Mitsubishi Eclipse and the 2004-2012 Mitsubishi Galant, one caliper for the rear right side of each. The rear left is a separate part, and the two are normally replaced together on that axle.

    Specifications

    Fit and size

    • Position: Rear right
    • Quantity per vehicle: 1
    • Piston quantity: 1
    • Piston diameter: 34.8 mm (1.37 in)
    • Mounting hole diameter: 0.394 in
    • Mounting type: M10x1.0
    • Bleeder thread size: M7x1.0
    • Inlet fitting: Inverted flare

    Build and materials

    • Caliper type: Floating, unloaded
    • Casting material: Cast iron
    • Piston material: Steel
    • Finish: Zinc plated, with a rust-resistant coating
    • Pad wear sensor: Included
    • Condition: New
    • Country of origin: Republic of Korea

    In the box

    One caliper with its bracket, hardware kit, bleeder screw and instruction sheet. Brake pads and mounting bolts are not included; plan on new mounting bolts, since the old ones may not be reusable.

    Installation notes

    • An instruction sheet comes with the caliper for the steps.
    • A silicone grease is used on floating caliper mounting pins.

    Interchange: 4605A017

    Product information is for general reference and may contain errors. See our Disclaimer.

    This part cross-references / interchanges with the following part numbers:

    4605A017

    Frequently Asked Questions

    Is 2C-2966 among the brake calipers for the 2006-2012 Mitsubishi Eclipse?

    Yes. A1 CARDONE 2C-2966 is a rear right caliper for the 2006-2012 Mitsubishi Eclipse, and it also fits the 2004-2012 Mitsubishi Galant.

    Does the A1 CARDONE caliper come with its bracket and hardware?

    Yes. A1 CARDONE 2C-2966 comes with the bracket, a hardware kit, a bleeder screw and an instruction sheet. Brake pads and mounting bolts are not included.

    What are the piston size and material on this A1 CARDONE brake caliper?

    A1 CARDONE 2C-2966 has one steel piston, 34.8 mm (1.37 in) across, in a floating caliper with a cast iron body and a zinc-plated finish.

    What are signs a rear disc brake caliper is sticking or leaking?

    The car pulling to one side when braking, uneven pad wear or brake fluid around the caliper can all mean a caliper problem. A shop can test it, since other brake parts cause similar signs.

    Does A1 CARDONE 2C-2966 replace number 4605A017?

    Yes. 4605A017 is a cross-reference number for this rear right caliper, so it can be used to match it against an older part.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review