CARDONE New Disc Brake Caliper P/N:2C-2880
A1 CARDONE 2C-4975A front left brake caliper for the 2009 Ford F-150 and other vehicles clamps the brake pads against the rotor to slow the wheel. It is a new, unloaded floating disc brake caliper, so brake pads are bought separately.
Pulling toward one side under braking, fluid around the caliper or pads that wear unevenly can mean a caliper is sticking or leaking. Binding slide pins, a restricted brake hose, worn pads or a worn rotor can be behind these signs too, so find the cause before buying. Each front wheel takes one caliper.
This is a direct-fit replacement for the 2009 Ford F-150 and the 2009-2014 Ford Lobo, engineered to meet or exceed O.E. performance. The listing is one caliper for the front left; the front right is a separate part, and the front axle's pair is normally done at the same time.
Fit and size
Build and materials
One caliper, bracket, hardware kit, instruction sheet, bleeder screw, abutment clips and pad wear sensor. Brake pads and mounting bolts are not included; plan on new bolts.
Interchange: 7L3Z2B121A
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does this 2009 Ford F-150 brake caliper fit the left front wheel?
Yes. A1 CARDONE 2C-4975A is a front left caliper for the 2009 Ford F-150 and the 2009-2014 Ford Lobo; the front right side takes a separate caliper.
What comes with this A1 CARDONE brake caliper?
A1 CARDONE 2C-4975A arrives with a bracket, hardware kit, instruction sheet, bleeder screw, abutment clips and pad wear sensor. Brake pads and mounting bolts are not included.
Does the A1 CARDONE caliper use phenolic or steel pistons?
Phenolic. This front left caliper has two 54 mm (2.13 in) pistons, and swapping phenolic for steel pistons is not recommended; the vehicle maker chose one for the intended use.
Is a car pulling to one side when braking a caliper problem?
It can be. A sticking caliper may pull the car toward one side, though a collapsed brake hose or worn steering and suspension parts can do it too. Have the brakes inspected promptly.
What brake fluid and grease go with this floating caliper?
Use the brake fluid the vehicle maker specifies; the type is stamped on the master cylinder reservoir lid, from a new sealed container. Floating caliper mounting pins take silicone grease.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.