CARDONE Reman Disc Brake Caliper 18-B5331

CARDONE Reman Disc Brake Caliper P/N:18-B5331

Be the first to review this product

$178.99

MPN: 18-B5331

UPC: 884548115668

Item Package Quantity: 1

Current Stock:

Quantity:

Adding to cart… The item has been added

Have questions?

Ask an Expert

CARDONE Reman Disc Brake Caliper P/N:18-B5331

$178.99

Description

Get firm, even stops on the rear axle with the A1 CARDONE caliper, a remanufactured disc brake caliper (MPN 18-B5331) that clamps the pads against the rotor to convert hydraulic pressure into braking force. It installs as a direct-fit rear-right replacement for the 2011-2019 Chevrolet Silverado 3500 HD [All] and 2011-2019 GMC Sierra 3500 HD [All], and every unit is 100% pressure-tested before it ships.

Two phenolic pistons: a 2.246 in (57.04 mm) piston bore in a floating-type, cast iron caliper body.
New high-temperature EPDM rubber seals and dust boots: replaced during remanufacturing for extended sealing life.
Complete hardware and bracket: arrives with a new hardware kit, mounting bracket, bleeder screw, and a banjo inlet fitting for a straightforward installation.
Rust-resistant finish: treated with a rust inhibitor and kept in the original-equipment gray finish.

This A1 CARDONE brake caliper is supplied without pads or a pad wear sensor, so reuse or replace those separately. Country of origin: Mexico.

Interchange: 20909270

Manufacturer's Description

Product Specs

Buyer's Guide

Interchange Part Numbers

This part cross-references / interchanges with the following part numbers:

20909270

Frequently Asked Questions

Does this caliper come with brake pads?

No. Pads and a pad wear sensor are not included, so plan to reuse serviceable pads or install a new set separately. A new hardware kit and mounting bracket are included.

What brake fluid should I use?

Always use the brake fluid recommended by the O.E.; the type is stamped on the master cylinder reservoir lid. Use new fluid from a sealed container.

Can I switch a phenolic-piston caliper for a steel-piston caliper or vice versa?

It is not recommended. O.E. manufacturers specified steel or phenolic pistons based on the vehicle's intended use, so follow the manufacturer's recommendation.

Does this caliper include a mounting bracket and hardware?

Yes. This unit ships with a mounting bracket and a complete kit of new hardware, plus a new bleeder screw, for installation.

Could a caliper be the cause of a low brake pedal?

A low pedal is usually caused by air in the system, misadjusted rear brake shoes, a deteriorated brake hose, or a defective master cylinder. Diagnose the cause before replacing parts.