CARDONE Reman Mass Air Flow Sensor P/N:74-10084
A1 CARDONE 74-10022 mass air flow sensor for the 1990-1993 Volvo 240 4-cylinder 2.3L measures the air entering the engine and reports it to the engine control system. This remanufactured sensor tracks O.E. output curves and holds spec tolerances, so the engine computer and your scan tool get accurate readings.
Hesitation, stalling or poor fuel economy can mean the mass air flow sensor is failing. A cracked intake air duct or a clogged air filter can be behind the same trouble, so track down the cause before you replace it. This listing is one sensor, the single one the engine takes.
As a remanufactured original equipment part, this mass air flow sensor is a direct fit for the 1990-1993 Volvo 240 4-cylinder 2.3L.
Fit and size
Build and materials
One mass air flow sensor in its housing and one instruction sheet. Mounting hardware, a bracket and a wiring harness are not included, and the old bolts may not be reusable, so plan on new ones.
Interchange: 0280217001 · 3517881 · 35178813
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the A1 CARDONE 74-10022 right for the 1990-1993 Volvo 240 4-cylinder 2.3L?
Yes. The A1 CARDONE 74-10022 mass air flow sensor is a remanufactured original equipment part and a direct fit for the 1990-1993 Volvo 240 4-cylinder 2.3L.
Does this CARDONE mass air flow sensor come in its housing?
Yes. This mass air flow sensor comes in its housing with an instruction sheet; the wiring harness, bracket and mounting hardware are not included.
What are the inlet and outlet sizes on the 74-10022 housing?
The A1 CARDONE 74-10022 housing has a 2.75 in (69.85 mm) inlet and a 2.76 in (70.1 mm) outlet, with one rectangular male connector carrying 4 pin terminals.
How can I tell if a MAF sensor element is bad?
With the engine off and cool, look at the sensor element for damage and check for a burnt smell. A scan tool can also read any stored diagnostic trouble codes.
What goes bad inside mass air flow sensors like this one?
The most common faults are cracked circuit boards, burnt sensing elements, poor solder joints, deteriorated conformal coating or loose circuit board components. This remanufactured sensor has its critical components 100% re-soldered.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.