CARDONE Reman Mass Air Flow Sensor P/N:74-10084
A1 CARDONE 74-10117 mass air flow sensor for the 2003-2004 Land Rover Range Rover V8 4.4L and other vehicles measures the air entering the engine and reports it to the engine control system. This remanufactured unit tracks O.E. output curves and holds spec tolerances so scan tool readings stay accurate.
A failing mass air flow sensor can show up as hesitation, stalling or poor fuel economy. These signs alone do not prove the sensor is the problem, since a vacuum leak can cause them too. If the sensor is at fault, this unit replaces it. The 2000-2003 BMW X5 V8 4.4L takes one.
It also fits the 2000-2003 BMW X5 V8 4.4L and the 2002-2003 X5 V8 4.6L, and it is the BMW 540i mass air flow sensor for the 1999-2003 540i V8 4.4L. If your vehicle is not named here, find your year and engine in the "Vehicles it fits" section.
Fit and size
Build and materials
One mass air flow sensor and one instruction sheet. Mounting hardware, a mounting bracket and a wiring harness are not included, so plan on new hardware, as the old pieces may not be reusable.
Interchange: 13621433567 · MHK000230
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a mass air flow sensor replacement for the 2000-2003 BMW X5 V8 4.4L?
Yes. A1 CARDONE 74-10117 is listed for the 2000-2003 BMW X5 V8 4.4L, and that engine takes one sensor. For another year or engine, look in the "Vehicles it fits" section.
Will this air flow sensor fit the 2002-2003 BMW X5 V8 4.6L?
Yes. The 2002-2003 BMW X5 V8 4.6L is covered by this mass air flow sensor, and it takes one.
What comes with the A1 CARDONE 74-10117 sensor, and is a wiring harness included?
No. The box holds one mass air flow sensor and an instruction sheet. The wiring harness, mounting hardware and mounting bracket are not included.
What connector does this remanufactured mass air flow sensor use?
This sensor has one rectangular male connector with 5 male pin terminals, in a plastic housing.
How can I check a mass air flow sensor for damage?
With the engine off and cool, look at the sensor element for damage and note any burnt smell. Then scan for diagnostic trouble codes; a shop can run further tests.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.