CARDONE Reman Mass Air Flow Sensor P/N:74-50047
A1 CARDONE 74-10118 mass air flow sensor for the 2005-2008 Volkswagen Jetta 5-cylinder 2.5L and other vehicles measures the air entering the engine and reports it to the engine control system. This remanufactured unit follows O.E. output curves and holds spec tolerances, so scan tool readings stay accurate.
Hesitation, stalling, poor fuel economy or weak engine performance can come from a failing mass air flow sensor, though other parts can cause them too. With the engine off and cool, look over the sensor element and housing for damage or a burnt smell, and have the codes read before you replace anything.
Listed for a wide range of Volkswagen models, this VW Jetta mass air flow sensor covers the 2005-2008 Jetta 5-cylinder 2.5L, the 2006-2010 Volkswagen Beetle 5-cylinder 2.5L and the 2010 Volkswagen Beetle Cabrio 5-cylinder 2.5L. This listing is a single sensor, and the 2005-2008 Jetta 5-cylinder 2.5L takes one. If your Volkswagen is not named here, look up your year and engine in the "Vehicles it fits" section.
Fit and size
Build and materials
One remanufactured mass air flow sensor and one instruction sheet. Mounting hardware, the mounting bracket and the wiring harness are not included; plan on new hardware, since the old pieces may not be reusable.
Interchange: 07C906461 · 07C906461X
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this maf sensor right for a 2005-2008 VW Jetta 5-cylinder 2.5L?
Yes. A1 CARDONE 74-10118 is listed for the 2005-2008 Volkswagen Jetta 5-cylinder 2.5L. If your Volkswagen is a different model or year, look it up in the "Vehicles it fits" section.
Is this the right VW Beetle mass air flow sensor for a 2006-2010 Beetle 5-cylinder 2.5L?
Yes. A1 CARDONE 74-10118 is listed for the 2006-2010 Volkswagen Beetle 5-cylinder 2.5L. The 2010 Volkswagen Beetle Cabrio 5-cylinder 2.5L is listed as well.
Does this mass air flow sensor come with mounting hardware or a wiring harness?
No. The box holds the sensor and an instruction sheet. Mounting hardware, the mounting bracket and the wiring harness are not included.
What size are the connections on this remanufactured mass air flow sensor?
The inlet connection is 3.16 in (80.26 mm) across. The electrical connector is rectangular with 5 male pin terminals.
What usually goes bad inside a mass air flow sensor?
Common failures are cracked circuit boards, burnt sensing elements, poor solder joints and loose circuit board components. These conditions require replacing the unit.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.