CARDONE Reman Power Steering Pump P/N:20-7828
A1 CARDONE 20-7853 power steering pump for the 1992-2000 Dodge Dakota and other vehicles pressurizes fluid to provide steering assist. This A1 CARDONE power steering pump is remanufactured and comes with its reservoir; its housing is cast iron.
A whine from the pump, heavy steering or assist that fades can mean the pump is wearing out, but other parts of the steering system can produce those symptoms too. Before replacing the pump, look it over with the engine off and cool for leaks at the hoses and fittings and for a cracked pulley.
The pump is listed for a wide range of Dodge models. It is a Dodge Dakota power steering pump replacement for the 1992-2000 model years, and it also fits the 1998-2000 Dodge Durango and the 1995-1996 Dodge B1500, with one pump per vehicle.
Fit and size
Build and materials
One power steering pump with its reservoir, a sealing kit and an instruction sheet. The pulley, reservoir cap, mounting hardware and filter are not included, so plan on new bolts rather than reusing the old ones.
Interchange: 52007101 · 52007104 · 52039489
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a 2000 Dodge Dakota power steering pump, and do other 1992-2000 Dodge Dakota years fit too?
Yes. A1 CARDONE 20-7853 is listed for the 1992-2000 Dodge Dakota, including 2000 models, and one pump goes on each truck.
Can I use this as a Durango power steering pump on a 1998-2000 Dodge Durango?
Yes. A1 CARDONE 20-7853 is listed for the 1998-2000 Dodge Durango. For any other Dodge truck or van, look up your year and model in the "Vehicles it fits" section.
Does this remanufactured pump come with a pulley or reservoir cap?
The pump includes its reservoir, a sealing kit and an instruction sheet. The pulley, reservoir cap, mounting hardware and filter are not included.
What thread size and inlet diameter does this power steering pump have?
The outlet thread is 16x1.5, and the barb inlet measures 10.74 mm (0.423 in) across. The pump has one inlet and one outlet, with an O-ring hose port.
My old pulley fits loosely on the new pump shaft. What should I do?
If the old shaft was mushroomed before the pulley came off, the pulley bore may be enlarged, and the pulley must be replaced. A pulley that cracked on removal also needs replacing.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.