CARDONE Reman Power Steering Pump P/N:20-1042
A1 CARDONE 20-823 power steering pump for the 1997-2002 Jeep Wrangler and other vehicles is a remanufactured pump that supplies the hydraulic pressure for steering assist. Each unit gets a hydraulic efficiency test, and the final assembly is computer-tested for pressure, bypass, fluid flow, valve operation, steering effort and noise.
A whining noise, hard steering in one direction, or assist only when engine rpm rises can all be signs of a worn pump. A binding steering gear or linkage, a slipping belt, contaminated fluid or a blocked flow control valve can be behind these signs too, so find the cause before buying a pump.
This is a power steering pump for the 1997-2002 Jeep Wrangler, the 1997-2002 Jeep TJ and the 1997-2000 Jeep Cherokee.
Fit and size
Build and materials
One power steering pump, one sealing kit and one instruction sheet. The pulley, reservoir, reservoir cap, filter and mounting hardware are not included, so plan on new bolts and fasteners. This listing is one pump, which is all these Jeeps need per vehicle.
Interchange: 52088018
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the A1 CARDONE 20-823 a power steering pump replacement for the 1997-2002 Jeep Wrangler?
Yes. A1 CARDONE 20-823 fits the 1997-2002 Jeep Wrangler, which takes one pump.
Does this 1997-2002 Jeep Wrangler power steering pump also fit the 1997-2000 Jeep Cherokee?
Yes. The same pump fits the 1997-2000 Jeep Cherokee, and it is also listed for the 1997-2002 Jeep TJ.
Does this power steering pump come with a pulley or reservoir?
No. The pulley, reservoir, reservoir cap, filter and mounting hardware are not included. The box holds the pump, a sealing kit and an instruction sheet.
How is this A1 CARDONE power steering pump tested?
Each A1 CARDONE 20-823 gets a hydraulic efficiency test, and parts like campacs and spool valves are tested three times. The pressure relief valve is calibrated, and the final assembly is computer-tested.
My old pulley is loose on the replacement pump shaft. What should I do?
The pulley may have cracked coming off, or a mushroomed shaft may have enlarged its bore. In that case the pulley must be replaced.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.