CARDONE Reman Power Steering Pump P/N:20-38771
A1 CARDONE 20-899 power steering pump for the 1995-1997 Dodge Intrepid and other vehicles supplies the hydraulic pressure behind the steering assist. This is a remanufactured A1 CARDONE power steering pump for a car whose original has gone noisy or weak.
A worn pump can whine, leave the steering stiff or leak fluid. Before you replace the pump, rule out binding steering components, a damaged pulley and contaminated fluid, because those can also make the steering hard or noisy.
This is a direct-fit power steering pump for the 1995-1997 Dodge Intrepid, the 1995-1997 Chrysler Concorde and the 1995-1997 Chrysler Intrepid, with more Chrysler, Dodge, Eagle and Plymouth models in the fitment. The 1995-1997 Dodge Intrepid takes one pump, and this listing is one pump. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One power steering pump, one sealing kit and one instruction sheet. The pulley, reservoir, reservoir cap and mounting hardware are not included, so plan on new mounting hardware rather than reusing the old.
Interchange: 4778520 · 4798348
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Will this Intrepid power steering pump fit a 1995-1997 Chrysler Intrepid?
Yes. A1 CARDONE 20-899 is listed for the 1995-1997 Chrysler Intrepid and the 1995-1997 Dodge Intrepid. Open the "Vehicles it fits" section to check your exact model and engine.
Does the A1 CARDONE 20-899 come with a pulley or reservoir?
No. The A1 CARDONE 20-899 comes with a sealing kit and an instruction sheet; the pulley, reservoir, reservoir cap and mounting hardware are not included.
What inlet and outlet fittings does this power steering pump have?
The inlet is a barb with a 17.4 mm (0.685 in) diameter. The outlet is threaded at 16x1.5, and the hose port type is O-ring.
My old pulley fits loosely on the A1 CARDONE 20-899 shaft. What should I do?
The pulley may have cracked on removal, or its bore may have enlarged if the shaft was mushroomed before the pulley came off. In that case the pulley must be replaced.
Is this remanufactured power steering pump tested before use?
Yes. Each unit goes through a hydraulic efficiency test, and the finished pump is computer-tested for pressure, bypass, fluid flow, valve operation, steering effort and noise.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.