Keep your caliper guide pins clean, sealed, and sliding freely with the Carlson Disc Brake Caliper Pin Boot Kit (MPN 16086). This guide-pin boot kit installs on the front and rear brake calipers of many vehicles, among them the 1998-2002 Toyota Corolla, 1997-2001 Toyota Camry, and 1998-2004 Toyota Avalon; see the Buyer's Guide tab for the full list. When brake friction material is replaced, the hardware is due as well — fresh boots help keep the guide pins free from dirt and debris for smoother caliper movement.
Approximate boot length is 1 in (25.4 mm). Country of origin: China.
Interchange: H18110 · FH16086 · 83493 · H16086 · 18050A
This part cross-references / interchanges with the following part numbers:
What does this kit do?
It supplies replacement rubber dust boots for the disc brake caliper guide pins, sealing out dirt and debris so the pins can slide freely for smoother, more consistent braking.
Which vehicles does the Carlson 16086 fit?
It fits the front and rear calipers of many vehicles, among them the 1998-2002 Toyota Corolla, 1997-2001 Toyota Camry, and 1998-2004 Toyota Avalon. See the Buyer's Guide tab for the full list.
Is caliper grease or a sleeve included?
No. The dust boots are included, but caliper grease, sleeves, nuts, washers, and instructions are not included.
When should I replace the pin boots?
Brake experts recommend replacing guide-pin hardware whenever the brake friction material is replaced. Torn or hardened boots that let debris reach the pins are also signs the kit may be due.
What are the boots made of?
The dust boots are made of black rubber and measure about 1 in (25.4 mm) in length.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
