Help keep your disc brakes clamping square and quiet with the Carlson disc brake caliper pin kit, MPN H5064. These caliper guide pins let the caliper slide as the pads wear, holding the piston and pads in position so the friction material meets the rotor at the correct angle. It's a direct-fit replacement, cataloged for front and rear positions, for many vehicles, including the 1997-2003 Ford F-150, 1995-2001 Ford Explorer and 1995-2008 Ford Ranger. See the Buyer's Guide tab for the full list and engine coverage.
Signs the guide pins may need replacing include seized or sticking calipers, uneven pad wear, and brake drag or noise. Replace hardware alongside pads for best results.
Interchange: H14903 · FHH5064 · H5065
This part cross-references / interchanges with the following part numbers:
What is the Carlson brake caliper pin kit H5064?
It's a kit of disc brake caliper guide pins, cataloged for front and rear positions, that let the caliper slide as the pads wear, holding the piston and pads in position for even braking.
Does this kit fit my vehicle?
It's a direct fit for many vehicles, including the 1997-2003 Ford F-150, 1995-2001 Ford Explorer and 1995-2008 Ford Ranger. Check the Buyer's Guide tab for your exact year and engine.
Should I replace the guide pins when I do a brake job?
Brake service experts recommend renewing caliper hardware whenever the friction material is replaced, since worn or seized pins affect how the caliper slides.
What are signs my caliper guide pins need replacing?
Common signs include seized or sticking calipers, uneven pad wear, and brake drag or noise. Diagnose the cause before replacing.
Are the pins corrosion protected?
Yes. The pins have a corrosion-resistant coating that helps them resist rust from harsh road conditions.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
