Carlson Disc Brake Hardware Kit 13466Q
Carlson Disc Brake Hardware Kit 13466Q

Carlson Disc Brake Hardware Kit P/N:13466Q

Be the first to review this product
$15.99
MPN: 13466Q
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Ask an Expert
Carlson Disc Brake Hardware Kit P/N:13466Q
Carlson Disc Brake Hardware Kit P/N:13466Q
$15.99

Keep your brake pads gliding smoothly and quietly with the Carlson disc brake hardware kit 13466Q, a direct-fit rear brake hardware set for the 2006-2014 and 2017-2018 Toyota RAV4 (see the Buyer's Guide tab for engine details). These abutment/pad clips locate the pads so they move in a uniform, stable motion instead of shifting freely, which is important for consistent contact and effective stopping.

  • Stainless steel, dual coated: built to suppress high stress levels and hold up to harsh road conditions.
  • Low-friction PTFE coating: reduces friction and drag as the pads slide against the clips.
  • Rubber compound: designed to virtually eliminate brake noise.
  • Corrosion-resistant coating: helps protect the hardware against harsh roads.

This part matches Original Equipment (OE) quality specifications, meaning it is at least as good as, if not better than, the original part supplied with the vehicle. Worn or corroded clips can let the pads bind or rattle; if the hardware is the cause, replacing it helps restore safe, uniform pad movement. Fresh clips are a smart addition whenever you service the rear pads on your Carlson brake hardware kit application.

Interchange: H16194A · FH13466Q · 83639A · H15945A

This part cross-references / interchanges with the following part numbers:

13466Q, H16194A, FH13466Q, 83639A, H15945A

Frequently Asked Questions

What vehicles does the Carlson disc brake hardware kit 13466Q fit?

It is a direct-fit rear brake hardware kit for the 2006-2014 and 2017-2018 Toyota RAV4. Check the Buyer's Guide tab to confirm the exact fit for your vehicle.

What is in this brake hardware kit?

It supplies the rear disc brake pad/abutment clips that locate and guide the pads. See the Buyer's Guide tab for application-specific contents.

Why should I replace the brake clips when I do a brake job?

Worn or corroded clips can let pads move freely, bind, or rattle. Fresh clips help keep the pads moving in a uniform, stable motion for consistent contact.

What are the clips made of?

They are stainless steel, dual coated, with a low-friction PTFE coating to reduce drag and a rubber compound to help suppress brake noise.

Does this Carlson brake hardware kit meet OE standards?

Yes. It matches Original Equipment (OE) quality specifications, meaning it is at least as good as, if not better than, the original part supplied with the car.

Related Products

!