Keep your front disc brakes moving smoothly and quietly with the Carlson disc brake hardware kit H5681Q. Brakes are engineered as a system, and fresh clips help the pads slide in a uniform, stable motion instead of shifting freely. It installs as a direct-fit replacement for the listed applications, including the 2004-2008 Chrysler Pacifica, 2003-2011 Ford Crown Victoria, 2003-2004 Ford Grand Marquis, 2003-2005 Lincoln Aviator, 2003-2011 Lincoln Town Car, 2003-2011 Mercury Grand Marquis, and 2003-2004 Mercury Marauder — see the Buyer's Guide tab for the full list and engine details.
- Friction-cutting clips: the special clip design uses PTFE to reduce friction and a rubber compound to help quiet brake noise.
- OE-quality build: matches Original Equipment (OE) quality specifications for a proper fit.
- Helps prevent noise and premature wear by keeping the pads properly located and moving uniformly.
- Corrosion resistant to hold up against harsh road conditions.
Replacing worn or corroded hardware whenever you change pads is important for keeping the pads seated and sliding correctly. This Carlson brake hardware kit is a direct replacement designed to drop in without modification.
Interchange: H5700 · FHH5681Q · 83366A · H5686A
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What does the Carlson disc brake hardware kit H5681Q include and do?
It supplies the clips and hardware that keep your front disc brake pads properly located and sliding uniformly, helping quiet noise and reduce premature wear.
Does this kit fit my vehicle?
It's a direct-fit replacement for the listed applications, including the 2003-2011 Ford Crown Victoria, 2003-2011 Lincoln Town Car, and 2004-2008 Chrysler Pacifica. Check the Buyer's Guide tab to confirm your vehicle and engine.
Is this a front or rear hardware kit?
This is a front disc brake hardware kit for the listed applications.
How do the clips help reduce brake noise?
The special clip design uses PTFE to reduce friction and a rubber compound to help virtually eliminate brake noise, keeping the pads moving in a stable, uniform motion.
Should I replace the hardware when I install new brake pads?
Yes. Changing the clips helps ensure the pads move uniformly instead of freely, so fitting fresh hardware with new pads helps prevent noise and premature wear.
Write a Review