Keep your engine's belt-driven accessories turning with the Dayco accessory drive belt, part number 15555. This bottom-cog V-belt loops over the engine's pulleys to carry drive to the accessories it runs. It fits many vehicles, among them the 1980-1985 Chevrolet Impala, 1978-1983 Chevrolet Malibu and 1980-1987 Chevrolet Camaro. See the Buyer's Guide tab for every application and engine code.
Most listed applications use one belt, but the quantity varies by application. A V-belt may need replacing if it squeals, shows cracks or glazing, frays, or slips on the pulleys. Check the pulleys and belt tension when you fit the new belt, since those can cause the same symptoms. Route and tension the belt as the vehicle service information directs.
Country of origin: Indonesia.
What does the Dayco 15555 accessory drive belt do?
It is a V-belt that loops over the engine's pulleys to drive the belt-powered accessories on the listed applications.
Which vehicles does the Dayco 15555 fit?
It fits many vehicles, including the 1980-1985 Chevrolet Impala, 1978-1983 Chevrolet Malibu and 1980-1987 Chevrolet Camaro. See the Buyer's Guide tab for every application and engine.
What size is this belt?
It has a 0.44 in top width, a 55.50 in (1409.70 mm) effective length, a 56.07 in (1424.18 mm) outside circumference and a 36-degree angle.
What is the belt made of?
It is made from a synthetic rubber compound with bottom-cog construction. It is listed to SAE J636 and SAE J637 and rated for -35°F to 175°F.
What are signs the belt may need replacing?
Squealing, cracks, glazing, fraying or slipping can point to a worn belt. Pulley or tension problems can cause the same signs, so check those before replacing the belt.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
