Delphi Steering Tie Rod End Adjusting Sleeve P/N:TA5913
$32.99
(You save)
Dial in accurate toe alignment and keep your steering linkage tight with the Delphi Steering Tie Rod End Adjusting Sleeve TA5913. This threaded sleeve connects the inner and outer tie rod ends — rotating it lengthens or shortens the tie rod assembly so an alignment technician can set toe to specification. It drops in as a direct-fit replacement for the 1963-1982 Chevrolet Corvette.
Tested to the extreme: withstands temperatures below -40°C and above 120°C and is exposed to 720 hours of salt spray, backed by Delphi's extensive dimensional and material analysis.
Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.
Fatigue tested: to help avoid in-service failure.
Complete job: Delphi includes the necessary accessories.
Signs the sleeve may need replacing include seized or corroded threads that prevent alignment adjustment, or a loose connection at the tie rod ends. If a worn or rusted adjusting sleeve is behind your alignment or steering-play issue, this replaces it — have the cause diagnosed and the toe reset after installation.
This part cross-references / interchanges with the following part numbers:
3826816, S677, ES677S, MS50739, JSA1019
Frequently Asked Questions
What does a tie rod end adjusting sleeve do?
It threads between the inner and outer tie rod ends. Rotating the sleeve lengthens or shortens the tie rod assembly, allowing a technician to adjust toe alignment to specification.
What vehicle does the Delphi TA5913 fit?
It is a direct-fit replacement for the 1963-1982 Chevrolet Corvette. See the Buyer's Guide tab to confirm fitment for your specific vehicle.
Does it include the hardware needed for installation?
Delphi includes the necessary accessories for a complete job. Consult the vehicle service information for the correct torque and installation procedure.
What are signs the adjusting sleeve should be replaced?
Seized or corroded threads that won't allow adjustment, or a loose fit at the tie rod ends. Have the cause diagnosed and get a wheel alignment after replacement.
Which part numbers does the TA5913 interchange with?
It cross-references 3826816, S677, ES677S, MS50739, and JSA1019.
Write a Review
Delphi
Delphi Steering Tie Rod End Adjusting Sleeve P/N:TA5913
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Keep your front-end toe adjustable and your steering linkage clamped tight with the Delphi Steering Tie Rod End Adjusting Sleeve TA2147. This front adjusting sleeve threads between the inner and...
Dial in accurate front-end alignment with the Delphi Steering Tie Rod End Adjusting Sleeve TA5901. This threaded sleeve joins the inner and outer tie rod ends and lets a technician rotate it to set...
Set your toe and tie the steering linkage together with the Delphi Steering Tie Rod End Adjusting Sleeve TA5877, the right-side sleeve that spans steering arm to steering arm on your Jeep. It drops...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
