Delphi Steering Tie Rod End P/N:TA2420

Be the first to review this product
$29.99
MPN: TA2420
UPC: 689604275399
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Delphi Steering Tie Rod End P/N:TA2420
Delphi Steering Tie Rod End P/N:TA2420
$29.99

Tighten up sloppy steering with the Delphi tie rod end TA2420, an inner steering tie rod end that connects the steering linkage and helps locate the front wheels so your steering inputs track precisely. It drops in as a direct-fit replacement for the 1991-1996 Dodge Dakota — see the Buyer's Guide tab for the full engine-level fitment.

  • OE-derived engineering: Delphi applies its OE steering expertise to the aftermarket, with parts validated below -40°C, above 120°C, and through 720 hours of salt spray.
  • Micron-tolerance ball stud: the stud is machined to micron tolerances for durable, smooth joint operation.
  • Fatigue tested: Delphi tie rods are fatigue tested to guard against failure.
  • Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.

Delphi includes the necessary accessories for a complete job. Signs this part may need replacing include loose or wandering steering, a clunk from the steering linkage, excess play at the wheel, and uneven front tire wear — diagnose the cause before ordering, and if a worn inner tie rod end is behind it, this replaces it. This inner tie rod end is sold individually; inspect the opposite side and replace as a pair where the service procedure directs.

Interchange: 1L5G6A666AB · IS252 · IS252PR · EV252 · GEV252 · MEV252 · JAR1166

This part cross-references / interchanges with the following part numbers:

1L5G6A666AB, IS252, IS252PR, EV252, GEV252, MEV252, JAR1166

Frequently Asked Questions

Will this Delphi tie rod end fit my Dodge Dakota?

Yes — the TA2420 is a direct-fit inner steering tie rod end for the 1991-1996 Dodge Dakota. Check the Buyer's Guide tab to confirm the exact fit for your vehicle.

Is this an inner or outer tie rod end?

This is an inner steering tie rod end. Confirm which position you need for your Dakota before ordering, as inner and outer units are different parts.

What are the signs I need a Dodge Dakota tie rod replacement?

Loose or wandering steering, excess play at the wheel, a clunk from the steering linkage, and uneven front tire wear can all point to a worn tie rod end. Diagnose the cause first.

Does it come with the hardware needed to install it?

Delphi includes the necessary accessories for a complete job. Always follow the vehicle service information for the correct install procedure and torque specs.

How is this Delphi tie rod built for durability?

The ball stud is machined to micron tolerances for smooth operation, the joint is fatigue tested, and each part gets anti-corrosion protection, validated through 720 hours of salt spray.