Tie Rod End for 2023-2025 Volkswagen Jetta & More - Delphi TA3648

$34.99
WARNING:California Proposition 65▾

Vehicles this part fits

    Part number: TA3648
    UPC: 689604402429
    Condition: New
    Weight: 1.70 LBS
    Item Package Quantity: 1
    $34.99
    Adding to cart… The item has been added

    Have questions?

    Delphi Steering Tie Rod End P/N:TA3648
    Delphi Steering Tie Rod End P/N:TA3648
    $34.99
    $34.99

    Delphi TA3648 tie rod end for the 2023-2025 Volkswagen Jetta and other vehicles sits at the inner position of the steering linkage and carries steering input toward the wheel through a ball stud joint.

    • Delphi's OE safety technology, with dimensional and material analysis for OE-to-aftermarket compatibility
    • Withstands temperatures below -40 degrees C and over 120 degrees C, plus 720 hours of salt spray
    • Includes the necessary accessories for a complete job
    • Ball studs machined to micron tolerances for durability and smooth joint operation
    • Delphi tie rods are fatigue tested to avoid failure, with anti-corrosion protection applied to each part

    Wandering steering, a clunk when turning or uneven tire wear can mean a worn steering tie rod end. Before you replace it, rule out worn ball joints, wheel bearings or an alignment problem, since each can produce similar symptoms. This listing is one piece, and both sides are normally replaced together.

    It is listed for a wide range of Volkswagen and Audi models, including the 2022-2025 Audi A3 Quattro and the 2022-2025 Audi RS3. A 2023-2025 Volkswagen Jetta takes two. If your car is not named here, look it up in the "Vehicles it fits" section by year and model.

    Specifications

    Fit and size

    • Position: Inner
    • Quantity per vehicle: 2

    Build and materials

    • Ball studs: machined to micron tolerances
    • Finish: anti-corrosion protection on each part

    Interchange: 1018824 · KRE4180

    Product information is for general reference and may contain errors. See our Disclaimer.

    This part cross-references / interchanges with the following part numbers:

    1018824, KRE4180

    Frequently Asked Questions

    Will the Delphi TA3648 work as a Jetta tie rod end on a 2023-2025 Volkswagen Jetta?

    Yes, the Delphi TA3648 is listed for the 2023-2025 Volkswagen Jetta and the 2022-2025 Audi A3 Quattro; for any other car, run your year and model through the "Vehicles it fits" section.

    Is a Delphi track rod end the same as the TA3648 tie rod end?

    Yes. Track rod end is another name for a tie rod end, and the Delphi TA3648 is the inner one.

    Before I read a Delphi tie rod review, how is the TA3648 tested?

    Delphi tests the TA3648 to withstand temperatures below -40 degrees C and over 120 degrees C, and exposes it to 720 hours of salt spray. The tie rods also go through fatigue testing.

    What signs can a worn inner tie rod end show?

    Steering that feels loose, pulling to one side or a knock over bumps can be signs. Steering play is best measured by a shop, so have it inspected promptly rather than driving on it.

    Does the Delphi TA3648 replace KRE4180 or 1018824?

    Yes. KRE4180 and 1018824 are both listed interchange numbers for the Delphi TA3648 tie rod end.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review