Delphi Suspension Ball Joint P/N:TC5287
Give worn front suspension a fresh pivot with the Delphi ball joint TC1670, a front lower suspension ball joint that connects the control arm to the steering knuckle so the wheel can steer and travel through its range. It's a direct-fit replacement for the 1995-2000 Ford Contour, 1999-2002 Mercury Cougar, and 1995-2000 Mercury Mystique — see the Buyer's Guide tab for engine-level fitment.
Delphi applies its OE engineering to its aftermarket steering portfolio, testing to the extreme — parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility. If a failed lower ball joint is behind your looseness, replacing it restores a solid pivot point for the front suspension.
Where does this ball joint mount?
It is a front lower suspension ball joint that connects the control arm to the steering knuckle, letting the front wheel steer and move through its suspension travel.
Will this fit my Ford Contour?
Yes — this Delphi TC1670 is a direct-fit replacement for the 1995-2000 Ford Contour. Check the Buyer's Guide tab to confirm the match for your specific vehicle and engine.
What vehicles does the TC1670 cover?
It fits the 1995-2000 Ford Contour, 1999-2002 Mercury Cougar, and 1995-2000 Mercury Mystique. See the Buyer's Guide tab for the full application details.
What are the signs a ball joint may need replacing?
Common signs include clunking or knocking over bumps, wandering or loose steering, and uneven front tire wear. Have the cause diagnosed before replacing.
What is the boot made of?
Delphi uses a chloroprene rubber boot, which helps improve durability and prevent premature failure by sealing grease in and keeping dirt and moisture out.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.