Front Upper Ball Joint for 1983-1988 Ford Ranger & More - Delphi TC1859

$50.99
WARNING:California Proposition 65▾

Vehicles this part fits

    Part number: TC1859
    UPC: 689604275474
    Condition: New
    Weight: 1.20 LBS
    Item Package Quantity: 1
    $50.99
    Adding to cart… The item has been added

    Have questions?

    Delphi Suspension Ball Joint P/N:TC1859
    Delphi Suspension Ball Joint P/N:TC1859
    $50.99
    $50.99

    Keep your steering tight and the front suspension pivoting smoothly with the Delphi Suspension Ball Joint TC1859, a front upper ball joint that drops in as a direct-fit replacement for the 1983-1988 Ford Ranger and 1986-1988 Ford Bronco II. This ball joint carries Delphi's OE steering expertise into an aftermarket unit that is tested to extremes — validated below -40°C and above 120°C and put through 720 hours of salt spray — with extensive dimensional and material analysis to keep it compatible with the original.

    • Forged strength: built with high-quality forgings for added strength and smooth operation.
    • Chloroprene boot: a chloroprene rubber boot improves durability and helps guard against premature failure.
    • Micron tolerances: machined to micron tolerances for durable, smooth joint operation.
    • Anti-corrosion finish: anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance.

    The ball joint is the pivot that connects the control arm to the steering knuckle, letting the wheel steer and the suspension travel. If a worn joint is the cause of clunking over bumps, wandering steering, or uneven tire wear, this replaces it. Replacing both sides as a pair is good practice for balanced handling.

    Interchange: 101-5198 · E3TZ-3049A
    1015198 · E3TZ3049A · B8414 · B8414PR · K8414 · K8560T · GK8414 · MK8414 · JBJ7025

    Product information is for general reference and may contain errors. See our Disclaimer.

    This part cross-references / interchanges with the following part numbers:

    101-5198, E3TZ-3049A, B8414, B8414PR, K8414, K8560T, GK8414, MK8414, JBJ7025

    Frequently Asked Questions

    Will this Delphi ball joint fit my 1983-1988 Ford Ranger?

    It is a direct-fit replacement for the 1983-1988 Ford Ranger and the 1986-1988 Ford Bronco II. See the "Vehicles it fits" section to confirm your exact vehicle and engine.

    What position is the TC1859 ball joint?

    It is cataloged as the front upper ball joint for the listed applications.

    What does a ball joint do, and when is a replacement needed?

    The ball joint pivots the control arm and knuckle. Signs it may need replacing include clunking over bumps, wandering steering, and uneven tire wear — diagnose the cause first.

    Should I replace both ball joints at once?

    This listing is for one ball joint. Replacing both sides together as a matched pair is recommended for balanced, even handling, though not strictly required.

    What makes this ball joint durable?

    It uses high-quality forgings, a chloroprene rubber boot, micron-tolerance machining, and an anti-corrosion finish, and is tested from below -40°C to over 120°C plus 720 hours of salt spray.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review