Delphi Suspension Ball Joint P/N:TC3403
Keep every steering and suspension input tracking true with the Delphi Suspension Ball Joint TC409 — a front lower ball joint that forms the pivoting connection between the control arm and steering knuckle, letting the suspension travel and the wheel steer while helping support and locate the front suspension. This Delphi ball joint is a direct-fit replacement for the 1985-1988 Chevrolet Nova and the 1984-1988 Toyota Corolla; see the Buyer's Guide tab for full engine coverage.
Delphi's OE safety technology is fitted to millions of vehicles worldwide, and this aftermarket steering part draws on that OE expertise — tested to withstand temperatures below -40°C and over 120°C, plus 720 hours of salt spray, with extensive dimensional and material analysis for OE-to-aftermarket compatibility. A worn ball joint may show up as clunking over the suspension, uneven tire wear, or loose steering — if the original joint is the cause, this replaces it.
Interchange: 101-3974 · 43330-29135 · 43330-29205
1013974 · 4333029135 · 4333029205 · B9342 · B9342PR · K8537 · K9342 · GK9342 · MK9342 · 4332029136 · JBJ7608
This part cross-references / interchanges with the following part numbers:
What vehicles does this Delphi ball joint fit?
It is a direct-fit replacement for the 1985-1988 Chevrolet Nova and the 1984-1988 Toyota Corolla. Check the Buyer's Guide tab to confirm the fit for your exact vehicle and engine.
Is this a front or rear ball joint?
This is a front lower ball joint. It connects the lower control arm to the steering knuckle, allowing suspension travel and steering movement.
What are signs this ball joint may need replacing?
Common signs include clunking over bumps, loose or wandering steering, and uneven tire wear. Have the cause diagnosed first, since these symptoms can come from other suspension parts.
What type of boot does this ball joint use?
It uses a chloroprene rubber boot, which improves durability and helps prevent premature failure by keeping dirt and moisture out of the joint.
How is the joint protected against corrosion?
Anti-corrosion protection is applied to each part for corrosion prevention and enhanced aesthetics, and Delphi tests its parts to 720 hours of salt spray.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.