Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2929
$266.99
(You save)
Give your steering and suspension the geometry it was built with using the Delphi Suspension Control Arm and Ball Joint Assembly TC2929 — a Nissan Altima control arm that installs in the front right lower position on the 2002-2006 Nissan Altima and 2004-2008 Nissan Maxima. This integrated unit combines the lower control arm with its ball joint, locating the wheel and allowing suspension travel while the pressed-in joint carries steering and articulation.
Key features:
OE-derived engineering: Delphi applies its OE steering expertise to the aftermarket; parts are tested from below -40°C to over 120°C and through 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
Quality verification: 100% crack detection and ultrasonic flaw detection help confirm materials meet OE specifications.
Machined ball studs: studs machined to micron tolerances for durability and smooth joint operation.
Built for consistency: robot welding for repeatable quality, plus anti-corrosion protection applied to each part for corrosion prevention and improved appearance.
Worn control arms and ball joints can show up as clunks, loose steering, or uneven tire wear. If a failed lower control arm or ball joint is the cause, this assembly replaces both at once.
What vehicles does the Delphi TC2929 control arm fit?
It fits the front right lower position on the 2002-2006 Nissan Altima and 2004-2008 Nissan Maxima. See the Buyer's Guide tab to confirm your exact vehicle and engine.
Is this a lower control arm for a Nissan Altima?
Yes. It is the front right lower control arm and ball joint assembly for the listed Altima and Maxima applications.
Does the ball joint come with this Delphi control arm?
Yes. The ball joint is integrated into the assembly, so you replace the control arm and its ball joint together as one unit.
What are signs this control arm may need replacing?
Clunking over the suspension, loose or wandering steering, and uneven tire wear can indicate a worn control arm or ball joint. Diagnose the cause before replacing.
How is the Delphi control arm tested for durability?
Delphi tests from below -40°C to over 120°C, runs 720 hours of salt spray, and uses 100% crack and ultrasonic flaw detection to confirm materials meet OE specifications.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2929
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Steady your steering and locate the front wheel with the DELPHI control arm and ball joint assembly TC6265, a direct-fit replacement for the front right lower position on the 2001 Chrysler Sebring,...
Keep your rear suspension tracking straight with the DELPHI control arm and ball joint assembly, part number TC7277. It's the rear right upper unit for the 2004-2009 Nissan Quest, pairing the control...
Get precise steering and secure wheel location with the Delphi control arm and ball joint assembly TC763, the front right lower unit for the 1985-1987 Volkswagen Golf and Jetta. This is a Delphi...
Keep the front suspension properly located and pivoting smoothly with the Delphi control arm, MPN TC6663 — a front left lower control arm and ball joint assembly that pairs the arm with its...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
