Delphi TC3600 front right lower control arm with ball joint for the 2015-2018 Audi A8 Quattro and other vehicles links the wheel to the chassis. As a control arm and ball joint assembly, it joins both in one piece.
- Parts tested at temperatures below -40 °C and over 120 °C and through 720 hours of salt spray
- 100% crack detection and ultrasonic flaw detection on each control arm
- Ball studs machined to micron tolerances for smooth joint operation
- Robot-welded control arm for consistent performance and quality
- Anti-corrosion protection applied to each part
Quick facts
- Part: Delphi TC3600 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: 2015-2018 Audi A8 Quattro and other vehicles
- Position: Front right lower rearward
- Condition: New
A worn control arm or ball joint can show up as a clunk or knock from the front right over bumps, uneven tire wear or steering that wanders. Before you replace this arm, rule out other worn front suspension and steering parts, such as a sway bar link or a tie rod end, that can make similar noises.
Fits
This arm fits the 2015-2018 Audi A8 Quattro and the 2015-2018 Audi S8, and this position takes one arm on each. The listing is a single front right lower rearward arm; the front left is a separate part, and the other side of that axle is normally done at the same time.
Specifications
Fit and size
- Position: Front right lower rearward
- Quantity per application: 1
Build and materials
- Type: control arm with ball joint
- Finish: anti-corrosion protection
- Condition: New
Interchange: 102-8008 · 524-232
4H0 407 694 E · 4H0 407 694 F · 4H0407694G · CB12214 · CB12214PR · CMS701112
This part cross-references / interchanges with the following part numbers:
4H0 407 694 E, 4H0 407 694 F, 4H0407694G, 102-8008, 524-232, CB12214, CB12214PR, CMS701112
Frequently Asked Questions
Is the Delphi TC3600 control arm right for the 2015-2018 Audi A8 Quattro?
Yes. Delphi TC3600 is a front right lower rearward control arm with ball joint for the 2015-2018 Audi A8 Quattro. It also fits the 2015-2018 Audi S8.
Does this Delphi control arm come with the ball joint built in?
Yes. Delphi TC3600 is a control arm with ball joint, and the ball studs are machined to micron tolerances for smooth joint operation.
What testing does the Delphi TC3600 control arm go through?
Each control arm gets 100% crack detection and ultrasonic flaw detection. Delphi parts are tested below -40 °C and over 120 °C and exposed to 720 hours of salt spray.
How can I tell if the ball joint on a front lower control arm is worn?
A clunk or knock from the front suspension over bumps, uneven tire wear or loose-feeling steering can point to wear. A shop can check ball joint play safely, since that needs the vehicle raised.
Is Delphi TC3600 a replacement for 4H0407694G?
Yes. 4H0407694G is one of the numbers this Delphi TC3600 replaces, and the Interchange line lists the others.
