Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2548
Delphi TC384 front left upper control arm with ball joint for the 1976-1985 Mercedes-Benz 300D and other vehicles holds the wheel in position as the suspension moves. Sold as a control arm and ball joint assembly, it joins the arm and the ball joint in one piece.
A clunk over bumps, loose or wandering steering and uneven front tire wear can mean an upper arm or its ball joint is worn. These signs alone do not prove this arm is at fault, since a worn tie rod end can feel much the same.
Delphi TC384 is listed for a wide range of Mercedes-Benz models, including the 1978-1985 Mercedes-Benz 300CD and the 1979-1985 Mercedes-Benz 300TD, alongside the 1976-1985 Mercedes-Benz 300D.
Fit and size
Build and materials
One control arm with ball joint for the front left upper position. That side takes one, the front right upper is a separate part ordered separately, and both sides are normally replaced together.
Interchange: 101-3482 · 102-3482 · 123 330 4607
520755 · KSC5348 · CB28047 · CB28047PR · CB9050 · CK9050 · K9050 · RK9050 · 1233305207 · A1233305207 · CMK9050 · GK9050 · JTC289
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the Delphi TC384 front left upper control arm right for a 1976-1985 Mercedes-Benz 300D?
Yes. Delphi TC384 fits the 1976-1985 Mercedes-Benz 300D, and the "Vehicles it fits" section covers the other Mercedes-Benz models it is listed for.
Does this upper control arm come with the ball joint already attached?
Yes. The ball joint is part of this front left upper arm, and the listing is one arm for that position only.
Does Delphi TC384 interchange with number 101-3482?
Yes. 101-3482 is one of the numbers Delphi TC384 replaces, and the Interchange line at the bottom of the page lists the others.
How can I tell whether a front upper control arm is worn?
A clunk over bumps, wandering steering or uneven front tire wear can mean the arm or its ball joint is worn. A shop can inspect the arm and test the joint safely.
Is the Delphi TC384 tested for cold, heat and salt spray?
Yes. The Delphi TC384 is tested below -40 degrees C and above 120 degrees C and exposed to 720 hours of salt spray.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.