Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5160
$57.99
(You save)
Help tighten up your handling with the Delphi control arm and ball joint assembly (TC5160), a rear lower unit that locates the wheel and provides a fresh ball joint in one piece. It is a direct-fit replacement for many vehicles, among them the 1999-2005 Hyundai Sonata, 2001-2006 Kia Optima and 2002-2005 Hyundai XG350; see the Buyer's Guide tab for the full list. If a worn arm or ball joint is behind your clunking, uneven tire wear, or loose steering, this assembly replaces it.
OE-validated engineering: built on Delphi's OE steering expertise, with dimensional and material analysis for close compatibility between the OE and aftermarket part.
Tested to the extreme: validated below -40°C and above 120°C and exposed to 720 hours of salt spray.
Verified materials: 100% crack detection and ultrasonic flaw detection confirm materials match OE specifications.
Precision joint: ball studs machined to micron tolerances for durable, smooth joint operation; robot welding for consistent quality.
Anti-corrosion protection applied to each part for corrosion prevention and improved appearance.
Sold individually; replacing both rear lower control arms together is recommended for balanced suspension geometry.
Is this the right Hyundai Sonata control arm for a 1999-2005 Hyundai Sonata?
Yes. It is a direct-fit rear lower replacement for the 1999-2005 Hyundai Sonata, and it also fits the 2001-2006 Kia Optima and 2002-2005 Hyundai XG350. See the Buyer's Guide tab for every application.
Does this lower control arm include the ball joint?
Yes. The ball joint is integrated into the assembly, so you replace the control arm and its ball joint together in a single unit.
What are the signs this control arm may need replacing?
Common signs of a worn arm or ball joint include clunking over bumps, uneven tire wear, and loose or wandering steering. Diagnose the cause before replacing.
Do I need to replace both sides?
It is sold individually. Replacing both rear lower arms together is recommended for even, balanced suspension geometry, but not strictly required.
How is this Delphi part built for durability?
Delphi uses 100% crack and ultrasonic flaw detection to confirm materials match OE specifications, machines the ball studs to micron tolerances, and adds anti-corrosion protection to each part.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5160
Help maintain rear wheel control on your BMW with the Delphi control arm TC2953, a rear right control arm and ball joint assembly built with Delphi's OE expertise applied to its aftermarket steering...
Help bring precise steering geometry and a solid front end back to your Audi or Volkswagen with the Delphi control arm and integrated ball joint, MPN TC1343. This front lower forward assembly locates...
Steer with confidence and help restore proper suspension geometry with the Delphi control arm and ball joint assembly, MPN TC2230. This is the front right lower rearward unit, and it drops in as a...
Connect the front suspension to the chassis and give the wheel a proper pivot point with this Delphi control arm with ball joint, part number TC1755, built for the front left upper position. It fits...
Help maintain precise wheel location and smooth joint operation with the Delphi control arm — the Suspension Control Arm and Ball Joint Assembly TC1828, a front right upper rearward unit that locates...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
