Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5219
$80.99
(You save)
Steer with confidence and keep the front suspension geometry tight with the Delphi Suspension Control Arm and Ball Joint Assembly TC5219 — a Delphi control arm that pairs the front left upper arm with a pre-installed ball joint in one direct-fit unit. It drops in as a replacement for the 2011-2015 Dodge Durango and 2011-2015 Jeep Grand Cherokee (see the Buyer's Guide tab for the full engine-level applications). This is the upper control arm Jeep Grand Cherokee owners reach for when the original arm's bushings or ball joint wear out.
OE-derived engineering: Delphi applies its OE steering expertise to the aftermarket, with parts validated in temperatures below -40°C and above 120°C and through 720 hours of salt-spray exposure, backed by extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
Verified materials: 100% crack detection and ultrasonic flaw detection help confirm materials match OE specifications.
Precision ball stud: studs machined to micron tolerances for durability and smooth joint operation.
Consistent build: robot welding for repeatable quality across every arm.
Corrosion protection: anti-corrosion coating applied for corrosion prevention and enhanced appearance.
What position does this control arm and ball joint assembly cover?
It is the front left (driver's side) upper control arm with an integrated ball joint. It combines the arm, bushings, and ball joint into a single direct-fit unit.
Will the TC5219 fit my 2014 Jeep Grand Cherokee upper control arm application?
Yes, it is listed for the 2011-2015 Jeep Grand Cherokee, which includes 2014. Confirm your vehicle in the Buyer's Guide tab for engine-level fitment.
What vehicles does this Delphi control arm fit?
It fits the 2011-2015 Dodge Durango and 2011-2015 Jeep Grand Cherokee. See the Buyer's Guide tab for the complete engine-level application list.
How is this Delphi part tested for durability?
Delphi validates it below -40°C and above 120°C and through 720 hours of salt spray. Ball studs are machined to micron tolerances and materials pass 100% crack and ultrasonic flaw detection.
What are signs this control arm or ball joint may need replacing?
Common signs include clunking or knocking over bumps, loose or wandering steering, uneven tire wear, and cracked or worn bushings. Have the suspension diagnosed to confirm the cause before replacing.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5219
Shopping for a Honda Civic control arm? The Delphi Suspension Control Arm and Ball Joint Assembly (TC1075) is a front right upper unit that installs as a direct-fit replacement on the 1996-2000 Honda...
Keep your front suspension located and tracking properly with the Delphi Suspension Control Arm and Ball Joint Assembly TC1043 — a Honda Accord control arm built with Delphi's OE steering expertise...
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Keep your steering tight and your front wheel located with the Delphi Suspension Control Arm and Ball Joint Assembly TC5439 — a front left upper S10 control arm that installs as a direct-fit...
Refresh worn rear suspension with the Delphi control arm assembly TC5994, a rear lower forward control arm and ball joint assembly that drops in as a direct-fit replacement for the 2006-2012 Hyundai...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
