Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5428
$51.99
(You save)
Fit your Delphi control arm with confidence: the Delphi Suspension Control Arm and Ball Joint Assembly TC5428 mounts in the front right upper position and locates the wheel while the integrated ball joint allows the steering and suspension to pivot. It's a direct-fit replacement for the 1997-2001 Honda Prelude, giving you the arm and joint pre-assembled in one unit.
Delphi builds this Honda Prelude control arm to its OE engineering standards, applying the same expertise found on millions of vehicles worldwide:
Machined ball studs: the studs are machined to micron tolerances for durability and smooth joint operation.
Inspected materials: 100% crack detection and ultrasonic flaw detection help ensure materials match OE specifications.
Robot welding: control arms use robot welding for consistent performance and quality.
Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.
Delphi tests to the extreme, with parts withstanding temperatures below -40°C and over 120°C plus 720 hours of salt spray. Signs this Prelude control arm may need replacing include clunking on acceleration or over bumps, loose or wandering steering, and uneven tire wear.
What is the Delphi TC5428 control arm and ball joint assembly?
It's a front right upper suspension arm with the ball joint pre-installed, so you replace both the arm and joint as one direct-fit unit.
Does this Delphi control arm fit my Honda Prelude?
Yes, TC5428 is a direct-fit replacement for the 1997-2001 Honda Prelude. Confirm your vehicle in the Buyer's Guide tab before ordering.
What position does this control arm fit?
It fits the front right (passenger side) upper position on the listed Honda Prelude applications.
How is the Delphi ball joint made for durability?
Delphi machines the ball studs to micron tolerances for smooth joint operation, and the arms undergo 100% crack and ultrasonic flaw detection to match OE specifications.
What are signs this control arm may need replacing?
If the arm or ball joint is the cause, you may notice clunking on acceleration or over bumps, loose or wandering steering, and uneven tire wear. Diagnose the cause before replacing.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5428
Sharpen wheel location and quiet worn-joint noise with the Delphi control arm and ball joint assembly, MPN TC8063 — a rear left upper unit that installs as a direct-fit replacement for the listed...
Steer with confidence and quiet the front suspension with the Delphi Control Arm with Ball Joint TC5025, a front left upper control arm and ball joint assembly. This Ford Fusion control arm installs...
Sharpen your front-end feel with this Delphi control arm (MPN TC4692), a front right upper control arm and ball joint assembly that installs as a direct-fit replacement for the 2018-2023 BMW M5, the...
Restore precise steering and quiet wheel control with the Delphi control arm, part number TC1482 — a front right lower rearward suspension control arm and ball joint assembly that installs as a...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
