Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5811
$142.99
(You save)
Put Delphi's OE-proven engineering into your truck's front suspension with the Delphi control arm and its integrated ball joint, MPN TC5811. This front left lower control arm and ball joint assembly locates the wheel and provides the lower pivot for the steering knuckle, and it installs as a direct-fit replacement for the 2004-2010 Infiniti QX56, 2005-2013 Nissan Armada, and the 2004-2012 Nissan Titan.
Tested for OE performance: validated to Delphi's extreme standards — withstanding temperatures below -40°C and over 120°C plus 720 hours of salt-spray exposure — with dimensional and material analysis for close OE-to-aftermarket compatibility.
100% inspected: every arm receives crack detection and ultrasonic flaw detection so its materials match OE specifications.
Precision ball stud: machined to micron tolerances for durability and smooth joint operation.
Built and protected: robotic welding for consistent quality, with anti-corrosion protection applied for corrosion prevention and enhanced appearance.
If a worn ball joint or bushing is the cause of clunking, uneven tire wear, or wandering steering, this 2004-2012 Nissan Titan lower control arm replaces the failed original as a complete control arm unit.
Does this control arm fit my 2004-2012 Nissan Titan?
Yes — it fits the 2004-2012 Nissan Titan, plus the 2004-2010 Infiniti QX56 and 2005-2013 Nissan Armada. Check the Buyer's Guide tab to confirm your exact year.
What position does this part cover?
It is the front left (driver's side) lower control arm with an integrated ball joint.
Is the ball joint included?
Yes. The ball joint is built into this assembly, so you replace both the arm and the joint together in one unit.
What are signs my control arm or ball joint may need replacing?
Clunking over the front end, uneven or inner-edge tire wear, loose or wandering steering, and a cracked or torn ball joint boot are common signs the part may need replacing.
Should I replace both sides at the same time?
This listing covers the front left lower corner and is sold individually. Replacing both sides together is recommended for balanced handling; order the opposite side separately if you need it.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5811
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi TC3986 control arm with ball joint for the 2016-2023 Toyota Tacoma is the front left lower A-arm, which links the wheel end to the truck's frame and has the ball joint built in.Parts withstand...
The Delphi control arm TC5177 pairs the lower control arm and ball joint in one front-left assembly, giving the 2004-2009 Nissan Quest a pivot point that locates the wheel and lets the suspension...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
