Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC6395
$85.99
(You save)
Help keep your steering tight and your front suspension properly located with the Delphi control arm with ball joint, MPN TC6395. This front left upper unit installs as a direct-fit replacement for the 1986-1994 Nissan D21 and the 1995-1997 Nissan Pickup — see the Buyer's Guide tab for engine-level fitment.
OE-grade validation: Delphi applies its OE steering expertise to the aftermarket, testing below -40°C and above 120°C and through 720 hours of salt spray, with dimensional and material analysis for close OE compatibility.
100% inspected: every arm undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball stud: ball studs are machined to micron tolerances for durable, smooth joint operation.
Robot-welded & protected: robotic welding for consistent quality, plus anti-corrosion protection applied to each part for corrosion prevention and enhanced appearance.
The control arm locates the wheel and pivots the suspension while the integrated ball joint lets the knuckle steer and travel. Signs it may be time to replace the original include clunking over bumps, loose or wandering steering, and uneven tire wear — if a failed arm or joint is the cause, this assembly replaces both in one bolt-on part. Shoppers looking for a 1986-1994 Nissan D21 control arm get a ready-to-install front left upper unit.
It's a front left upper assembly for the 1986-1994 Nissan D21 and the 1995-1997 Nissan Pickup. Check the Buyer's Guide tab to confirm your engine and configuration.
What is a control arm and ball joint assembly?
It combines the control arm with a pre-installed ball joint in one unit, so you replace both together rather than pressing a new joint into the old arm.
What are signs my control arm or ball joint may need replacing?
Common signs include clunking over bumps, loose or wandering steering, and uneven tire wear. Have the cause diagnosed before replacing the part.
How is this Delphi part tested?
Delphi tests below -40°C and above 120°C and through 720 hours of salt spray, and each arm gets 100% crack and ultrasonic flaw detection to match OE specifications.
Do I need to replace both sides?
This listing is for one front left upper assembly. Replacing worn suspension parts in pairs can help balance handling, but follow your vehicle's service procedure.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC6395
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Steer straight and keep the front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly (TC3986), a direct-fit Tacoma lower control arm for the 2016-2022 Toyota Tacoma. It...
The Delphi control arm TC5177 pairs the lower control arm and ball joint in one front-left assembly, giving the 2004-2009 Nissan Quest a pivot point that locates the wheel and lets the suspension...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
