Delphi TC9064 front left lower control arm with ball joint for the 2019-2021 Hyundai Veloster links the front left wheel to the car's body. The ball joint comes attached, so this Delphi control arm replaces the arm and joint in one piece.
- Tested to withstand temperatures below -40 degrees C and over 120 degrees C, plus 720 hours of salt spray
- 100% crack detection and ultrasonic flaw detection on every control arm
- Ball studs machined to micron tolerances for durable, smooth joint operation
- Robot-welded arm for consistent quality
- Anti-corrosion protection applied to each part
Quick facts
- Part: Delphi TC9064 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: 2019-2021 Hyundai Veloster
- Position: Front Left Lower
- Condition: New
A clunk over bumps, vibration through the steering wheel or a wandering front end can mean the arm or its ball joint is worn. Other suspension parts make similar noises, so with the car parked and the engine off, look the arm and joint over for cracks, rust or other damage before you decide to replace it.
Fits
It works as a 2019-2021 Hyundai Veloster control arm for the front left lower position, and the car takes one on this side. The front right is a separate part ordered separately, and the two sides are normally replaced together.
Specifications
Fit and size
- Position: Front Left Lower
- Quantity per vehicle: 1 for this side
Build and materials
- Type: control arm with ball joint, sold as an assembly
- Corrosion protection: anti-corrosion protection on each part
- Condition: New
Interchange: 54500J3AA0 · X18CJ1525
Frequently Asked Questions
Does Delphi TC9064 fit the front left side of the 2019-2021 Hyundai Veloster?
Yes. Delphi TC9064 is the front left lower control arm with ball joint for the 2019-2021 Hyundai Veloster, and the car takes one on this side.
Is the ball joint already attached on this control arm and ball joint assembly?
Yes. This front left lower arm is sold as an assembly, so the ball joint is part of the piece and you do not buy it separately.
How are the ball studs on this control arm made?
Delphi TC9064 has ball studs machined to micron tolerances for durable, smooth joint operation. The arm itself is robot welded.
What temperature and salt-spray testing do these Delphi control arms go through?
Delphi parts withstand temperatures below -40 degrees C and over 120 degrees C and are exposed to 720 hours of salt spray. Each control arm also gets ultrasonic flaw detection.
What signs can show a lower control arm or ball joint is worn?
Uneven tire wear, a pull to one side or a loose steering feel can come from a worn arm or ball joint, or from other suspension parts. A shop can check the joint for play.
