Delphi Suspension Control Arm Bushing P/N:TD4041W
Cushion the rear upper control arm and take the harshness out of every bump with the Delphi Suspension Control Arm Bushing TD4211W. It is a direct-fit replacement for the listed applications and fits many vehicles, among them the 2005-2010 Hyundai Sonata, 2011-2013 Kia Sorento and 2006-2012 Hyundai Santa Fe; see the Buyer's Guide tab for the full list. It seats in the rear upper control arm to locate the arm, absorb road shock, and isolate suspension noise and vibration from the chassis.
If worn rear upper bushings are the source of clunking on acceleration or over bumps, cracked or deteriorated bushing material, or excess play, this bushing installs as a straightforward replacement. It is also a fitting control arm bushing for the 2006-2012 Hyundai Santa Fe.
Interchange: 55342-3K000
553423K000 · K200941 · MS90476 · JBU2006
This part cross-references / interchanges with the following part numbers:
What is a suspension control arm bushing and what does it do?
It cushions the connection between the control arm and the chassis, locating the arm while absorbing road shock and helping isolate noise and vibration. This unit fits the rear upper position.
Is this the right control arm bushing for a 2011-2013 Kia Sorento?
Yes, the 2011-2013 Kia Sorento is a listed application, along with the 2005-2010 Hyundai Sonata and 2006-2012 Hyundai Santa Fe. See the Buyer's Guide tab for the full list.
What are the signs a rear upper control arm bushing may need replacing?
Common signs include clunking on acceleration or over bumps, cracked or deteriorated bushing material, and excess play in the suspension. Diagnose the cause before replacing, as other parts can produce similar symptoms.
Does this bushing include the hardware needed for installation?
Delphi states it includes the necessary accessories for a complete job. Consult the vehicle service information for correct installation and torque procedures.
Is the Delphi TD4211W built to a quality standard?
Yes. It's designed to OE standards and tested below -40°C, above 120°C, and through 720 hours of salt spray, with dimensional and material analysis for close OE compatibility.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.