Delphi Suspension Control Arm P/N:TC8289
Delphi TC1053 front left lower control arm for the 1996-2003 Mercedes-Benz E320 and other vehicles connects the front left wheel assembly to the chassis. Catalogs also call it a suspension control arm; it lets the wheel travel up and down with the suspension.
A clunk over bumps, steering that wanders or uneven front tire wear can mean this arm is worn, though a tired tie rod end or sway bar link can be behind them too, so pin down the source before you replace anything.
The 1996-2003 Mercedes-Benz E320, the 1998-2002 Mercedes-Benz E430 and the 1999-2002 Mercedes-Benz E55 AMG are among the vehicles this arm fits. Drivers of other models can look up their car in the "Vehicles it fits" section. This listing is one arm for the front left; the axle needs one on each side, so the front right is a separate part, normally replaced at the same time.
Fit and size
Build and materials
Interchange: 101-5883 · 102-5883 · 520-587 · 210 330 3407 · 210 330 61 07 · 210 330 76 07 · 210 330 9007 · A210 330 3407 · A210 330 6107 · A210 330 7607 · A210 330 9007
KSC5329 · CA28193 · CA28323 · CA28323PR · K620088 · RK620088 · CMS101024 · MS101024 · JTC994
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does this Mercedes E320 control arm fit the 1996-2003 Mercedes-Benz E320?
Yes. Delphi TC1053 is the front left lower control arm for the 1996-2003 Mercedes-Benz E320. This listing is one arm for that side only.
Will this Mercedes E430 control arm fit a 1998-2002 Mercedes-Benz E430?
Yes. The 1998-2002 Mercedes-Benz E430 is covered. This arm goes on the front left lower position, and the right side is ordered separately.
How is this front left lower control arm protected against rust?
Anti-corrosion protection is applied to each part. The parts are also exposed to 720 hours of salt spray in testing.
How can I tell if a front lower control arm is worn?
With the engine off, you can look the arm over for cracks or heavy rust. A shop can test the joint for play, and a clunk over bumps is a reason to have the front suspension checked promptly.
What testing does the Delphi TC1053 go through?
Delphi TC1053 gets 100% crack detection and ultrasonic flaw detection, and the arm is robot welded. Its ball studs are machined to micron tolerances.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.