Delphi Suspension Control Arm P/N:TC9340

Be the first to review this product

$682.99

MPN: TC9340

UPC: 689604436424

Item Package Quantity: 1

Current Stock:

Quantity:

Adding to cart… The item has been added

Have questions?

Ask an Expert

Delphi Suspension Control Arm P/N:TC9340

$682.99

Description

Keep every mile of Jaguar handling precise and predictable with the Delphi control arm TC9340, a direct-fit front lower forward replacement for the 2010-2013 Jaguar XK, the 2010-2013 Jaguar XKR and the 2012-2013 Jaguar XKR-S. This suspension control arm locates the wheel, pivots through its mounting points and carries the ball stud that ties the knuckle to the chassis for controlled steering and ride.

OE-derived engineering: built on Delphi's OE safety expertise, with extensive dimensional and material analysis for close compatibility to the original part.
Tested to the extreme: withstands temperatures below -40°C and over 120°C and is exposed to 720 hours of salt spray.
Verified integrity: 100% crack detection and ultrasonic flaw detection confirm the materials match OE specifications, with robot welding for consistent quality.
Precision ball studs: machined to micron tolerances for durable, smooth joint operation, plus anti-corrosion protection applied to each part.

If a worn or damaged front lower forward arm is the cause of clunking, uneven tire wear or vague steering, this Delphi unit replaces it. Consult the vehicle service information for the correct fasteners and whether they may be reused.

Interchange: C2P17092

Manufacturer's Description

Product Specs

Buyer's Guide

Interchange Part Numbers

This part cross-references / interchanges with the following part numbers:

C2P17092

Frequently Asked Questions

Does this DELPHI control arm fit my Jaguar?

It's a direct-fit front lower forward replacement for the 2010-2013 Jaguar XK and XKR and the 2012-2013 Jaguar XKR-S. Check the Buyer's Guide tab to confirm your vehicle.

What position on the vehicle is this control arm?

It is the front lower forward control arm for the listed applications.

What are the signs a control arm may need replacing?

Clunking or knocking over bumps, uneven tire wear, and loose or wandering steering can indicate a worn control arm or ball stud. Diagnose the cause before replacing.

Does the arm include the ball stud?

Yes. The ball studs are machined to micron tolerances for durable, smooth joint operation as part of the arm.

What testing does Delphi perform on this part?

Each part undergoes 100% crack detection and ultrasonic flaw detection, temperature testing below -40°C and over 120°C, and 720 hours of salt-spray exposure.