Front Upper Control Arm Shaft Kit for 1971-1973 Chevrolet Impala & More - Delphi TC6505

Restore precise front-end geometry with the Delphi Suspension Control Arm Shaft Kit (TC6505), the inner pivot shaft hardware that the front upper control arm rotates on where it bolts to the frame. It's a direct-fit replacement for a long list of 1970-1973 GM full-size and intermediate cars, including the Chevrolet Camaro, Impala and Caprice, Buick Electra and Riviera, Oldsmobile 98 and Delta 88, and Pontiac Bonneville, Firebird and GTO — see the "Vehicles it fits" section for the full list of covered applications.

• OE-validated durability: Delphi tests to the extreme — parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt-spray exposure, with dimensional and material analysis for OE-to-aftermarket compatibility.
• Inspected to OE material specs: 100% crack detection and ultrasonic flaw detection confirm the materials match OE specifications.
• Consistent construction: robot welding for repeatable quality.
• Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.

Signs the original upper control arm shaft or its bushings may need attention include clunking or knocking from the front suspension over bumps, uneven or accelerated tire wear, and difficulty holding a front-end alignment. If a worn upper control arm shaft is the cause, this kit replaces it — have the front suspension inspected and an alignment performed after installation.

Interchange: 602244005 · 532263 · 356852 · 6258153 · K6148 · MS50933 · JTC1971