Delphi Suspension Stabilizer Bar Link Kit P/N:TC1850
$34.99
(You save)
Help keep body roll in check and address front-suspension rattles with the Delphi Suspension Stabilizer Bar Link Kit TC1850. This sway bar link connects the front stabilizer bar to the suspension and fits many vehicles, among them the 2002-2003 Chevrolet Trailblazer, 2002-2003 GMC Envoy and 2002-2003 Oldsmobile Bravada, installing in the front left position as a direct-fit replacement. See the Buyer's Guide tab for the full list and engine-specific fitment.
OE-derived engineering: Delphi applies its OE steering expertise to the aftermarket, with dimensional and material analysis for close compatibility between the OE and aftermarket part.
Tested to the extreme: validated below -40°C and above 120°C, and exposed to 720 hours of salt spray; the links are fatigue tested to help avoid failure.
Ultrasonic molding: manufactured to help prevent future weld breakage.
Micron tolerances: machined for durability and smooth joint operation, with anti-corrosion protection applied to each part.
Worn links can announce themselves with clunking or rattling over bumps and during cornering; if a failed link is the cause, this sway bar link kit replaces it. Sold as shown for the front left position.
It connects the front stabilizer (sway) bar to the suspension, helping control body roll and keep the bar working through the suspension's travel. This unit is for the front left position.
Which vehicles does the TC1850 fit?
It fits many vehicles, among them the 2002-2003 Chevrolet Trailblazer, 2002-2003 GMC Envoy and 2002-2003 Oldsmobile Bravada. See the Buyer's Guide tab for the full list and engine details.
How is this Delphi link tested for durability?
Delphi validates it below -40°C and above 120°C, exposes it to 720 hours of salt spray, and fatigue tests the links to help avoid failure. Anti-corrosion protection is applied to each part.
What are signs my sway bar link may need replacing?
Clunking or rattling over bumps and during cornering are common signs. Have the cause diagnosed first, since other suspension parts can produce similar noises.
What position is the TC1850 for?
The catalog lists it as the front left sway bar link. Confirm the side needed for your vehicle before installing.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Link Kit P/N:TC1850
Connect the stabilizer bar to the suspension and help keep body roll in check with the Delphi Suspension Stabilizer Bar Link Kit (TC1926). This rear right link installs as a direct-fit replacement...
Keep the front stabilizer bar tied to the suspension and quiet the rattles with the Delphi Suspension Stabilizer Bar Link Kit (TC879). This front stabilizer bar link kit is a direct-fit replacement...
Keep your stabilizer bar working with the suspension and help control body roll with the Delphi Sway Bar Link Kit TC1180. This kit connects the stabilizer bar to the suspension so the bar can resist...
Tie the rear stabilizer bar back to the suspension and keep body lean in check with the Delphi Suspension Stabilizer Bar Link Kit TC2146. This rear stabilizer bar link kit drops in as a direct-fit...
Keep your Mazda's front end composed through corners with the Delphi Suspension Stabilizer Bar Link Kit TC1417. This front sway bar link connects the front stabilizer bar to the suspension,...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
