Delphi Suspension Stabilizer Bar Link Kit P/N:TC5002
$19.99
(You save)
Keep body roll in check and reconnect your stabilizer bar to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC5002. This front sway bar link fits the 2001-2006 Hyundai Elantra and the 1995-1997 Hyundai Sonata — see the Buyer's Guide tab for engine-level fitment. The link ties the front stabilizer bar to the control arm or strut so the bar can resist lean through corners; if worn links are the source of clunking or excess body sway, this kit replaces them.
OE-engineered: Delphi's OE safety technology is fitted to millions of vehicles worldwide, and its dimensional and material analysis is applied to deliver strong compatibility between the OE and aftermarket part.
Tested to the extreme: validated below -40°C and above 120°C and exposed to 720 hours of salt spray for OE-level performance.
Built to last: fatigue tested to avoid failure and produced with ultrasonic molding to help prevent future weld breakage.
Precision joints: machined to micron tolerances for durability and smooth joint operation, with anti-corrosion protection applied to each part for corrosion prevention and enhanced aesthetics.
Sold as a stabilizer bar link kit for the front position.
It connects the front stabilizer (sway) bar to the suspension so the bar can resist body lean during cornering. It helps control body roll and keep the sway bar working as intended.
Does the TC5002 fit my vehicle?
It's a direct-fit replacement for the 2001-2006 Hyundai Elantra and the 1995-1997 Hyundai Sonata. Check the Buyer's Guide tab to confirm the application for your vehicle.
Is this a front or rear link?
This is a front stabilizer bar link kit, per the catalog position for the listed applications.
What are signs my sway bar links may need replacing?
Clunking or rattling over bumps, looseness in the joint, and increased body sway in turns can be signs. Diagnose the cause before replacing, as other suspension parts can produce similar symptoms.
How is this Delphi link protected against corrosion?
Anti-corrosion protection is applied to each part for corrosion prevention and enhanced aesthetics, and the link is validated through 720 hours of salt spray testing.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Link Kit P/N:TC5002
Keep body lean in check and quiet the clunks with the Delphi Rear Suspension Stabilizer Bar Link Kit (TC2616) — a direct-fit replacement for the 2002-2007 Mitsubishi Lancer (see the Buyer's Guide tab...
Keep your rear stabilizer bar tied firmly to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC2919. This rear-position sway bar link kit drops in as a direct-fit replacement for...
Tie the stabilizer bar back to the suspension and quiet front-end rattle with the Delphi Suspension Stabilizer Bar Link Kit TC2909. This front right sway bar link installs as a direct-fit replacement...
Tighten up front-end response and quiet the clunks with the Delphi Suspension Stabilizer Bar Link Kit TC6165. These front sway bar links connect the stabilizer bar to the suspension, transferring...
Quiet the clunks and keep the rear stabilizer bar tied to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC6526. This rear-position stabilizer bar link kit drops in as a direct-fit...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
